The Current Version For Cisco CCIE Routing & Switching 400-101 Exam Is V48.02

1. Drag and drop each IS-IS router type from the left onto the best matching OSPF router type on the right

2. Which two statements about route summarization are true?

3. Which two statements about Cisco IOS XE are true? (Choose two)

4. For which feature is the address family "rtf0ilter" used?

5. Drag and drop each NAT64 description from the left onto the corresponding NAT64 type on the right

6. In which way does the Bridge Assurance mechanism modify the default spanning-tree behavior in effort to prevent bridging loops?

7. Which two methods can you use to limit the range for EIGRP queries? (Choose two)

8. An IPv6 network has different MTUs on different segments If the network is experiencing reliability issues, which option is the most likely reason?

9. Which two OSPF network types require the use of a DR and BDR? (Choose two)

10. Drag and drop the BGP feature on the left to the corresponding function it performs on the right

11. Refer to the exhibit

W hich two actions can you take to allow the network 172.29.224.0/24 to be reachable from peer 192.168.250.53? (Choose two)

12. Refer to the exhibit

After you apply the given configurations to R1 and R2.

Which networks does R2 advertise to R1?

13. In an MPLS-VPN environment, what is the effect of configuring an identical set of route targets for a particular VRF but then configuring nonidentical RD accross multiple PE devices?

14. In which 802 1D port state are the root bridge, the root port, and the designated ports(s) elected?

15. Which two statements about IS-IS authentication are true? (Choose two)

16. Which two factors contribute to traffic starvation when TCP and UDP flows are included in a single traffic class? (Choose two)

17. Which two features are incompatible with Loop Guard on a port? (Choose two)

18. Which two BGP attributes are optional, non-transitive attributes? (Choose two)

19. Which two statements about VTPv3 are true? (Choose two)

20. Which two statements about IPv6 6to4 tunnels are true? (Choose two)

21. Which statement correctly describes Ansible operations and playbooks?

22. Which neighbor-discovery message type is used to verify connectivity to a neighbor when the link-layer address of the neighbor is known?

23. Which mechanism does GET VPN use to preserve ip header information?

24. Which Cisco PfR monitoring mode is recommended for Internet edge deployments?

25. Which prefix list matches and permits all RFC 1918 network 10 0 0 0 routes that have masks of /16 through /24?

26. Drag and drop the OSPFv3 LSA type on the left to the functionality it provides on the right

27. Drag each statement about EIGRP neighbor peering on the left the matching peering type on t right

28. Ping and Trace route extended options are very useful.

Which difference between using the Record option with the ping command vs the traceroute command is true?

29. Refer to the exhibit

Which IS-IS network type is enabled by default in this network?

30. Which three values are used to generate a unique bridge ID for each VLAN in PVST+? (Choose three)

31. Which statement describes the operation of the Generalized TTL Security Mechanism (GTSM), used by routing protocols to prevent some type of attack?

32. Refer to the exhibit

Which two actions can you take to allow the network 172.29.224.0/24 to be reachable from peer 192.168.250.53? (Choose two)

33. Which method can an IPv6 host use to learn the RP in an IPv6 multicast-enabled network?

34. Which three components are in an MPLS header? (Choose three)

35. Refer to the exhibit

You need to modify the IOS L3 switch configuration for High Availability operation.

What additional configuration is needed, if any?

36. On a network with multiple VLANs, which three tasks must you perform to configure IP source guard on VLAN 50 only? (Choose three)

37. Which two statements about PPP PAP are true? (Choose two)

38. Refer to the exhibit

While troubleshooting the failure of two devices to establish an IPSec tunnel, you generated the given debug output on R2.

What is the most likely reason the tunnel failed?

39. Refer to the Exhibit

What is the effect of the given configuration?

40. Which two statements about LDP are true? (Choose two)

41. Which two statements about native VLANs are true? (Choose two)

42. Which two limitations of PIM snooping are true? (Choose two)

43. Which routing protocol is not supported with VRF-lite?

44. Which statement about NAT64 is true?

45. When EIGRP Auto-Summary is enabled, what does Auto Summarization do in EIGRP?

46. Which are the two requirements for BGP to install a classful network into the BGP routing table? (Choose two)

47. Drag and drop the B GP attributes on the left to the correct category on th e right Not all options will be used

48. Which component of a GETVPN deployment is responsible for obtaining an IPsec SA to encrypt data within a group?

49. Drag each NTP command on the left to its effect on the right

50. Which two statement are true about IS-IS (choose Two)

51. Which two statements about PfR are true? (Choose two)

52. What are IPv6 addresses of the form FC00::/7 known as?

53. Which two conditions can cause unicast flooding? (Choose two)

54. Which technology uses MPLS to provide IPv6 connectivity to customers in the core network without the need for dual-stack?

55. What are three core features of GET VPN? (Choose three)

56. Which values does EIGRP use to determine the metric for a summary address?

57. What command can you enter to configure NBAR to recognize VNC traffic?

58. Which statement about a type 4 LSA in OSPF is true?

59. Which two statements about a flat single-hub DMVPN with NHRP are true? (Choose two)

60. Which two statements about IPv4 and IPv6 networks are true? (Choose two)