Get 200-125 Dumps V30.02 To Pass Cisco CCNA Exam

1. Drag and drop the descriptions of IP protocol transmissions from the left onto the correct IP traffic types on the right.

2. Refer to the exhibit.

What is the effect of the given configuration?

3. Which two circumstances can prevent two routers from establishing an EIGRP neighbor adjacency? (Choose two)

4. Drag and drop the extended traceroute options from the left onto the correct descriptions on the right.

5. Which command should you enter to configure a single port to discard inferior BPDUs?

6. Which command can you enter to verify that a router is synced with a configured time source?

7. Which NAT function can map multiple inside addresses to a single outside address?

8. Which command should you enter to verify the priority of a router in an HSRP group?

9. Which two functions describe benefits of aggregated chassis technology? (Choose two)

10. Refer to the exhibit.

Which VLAN ID is associated with PC B?

11. Which command should you enter on an interface in a vendor-neutral Ether Channel so that it will be selected first to transmit packets?

12. Which value is used to build the CAM table?

13. Refer to the exhibit.

Which three ports will be STP designated ports if all the links are operating at the same bandwidth? (Choose three)

14. According to security best practices, which two actions must you take to protect an unused switch port? (Choose two)

15. When you configure and boot a new device, when does the running configuration become active?

16. Which task must you perform to enable an IOS device to use DNS services?

17. Which type of routing protocol operates by using first-hand information from each device’s peers?

18. When troubleshooting client DNS issues, which two tasks must you perform? (Choose two)

19. What are two advantages of static routing? (Choose two)

20. Which two statements about UTP cables are true? (Choose two)

21. What is the effect of PortFast on the MAC aging process?

22. Which technology in a service provider environment can use labels to tunnel customer data?

23. Which two steps must you perform on each device that is configured for IPv4 routing before you implement osPFv3? (Choose two)

24. Which two statements about NTP operations are true? (Choose two)

25. Which two statements about southbound APIs are true? (Choose two)

26. Based on the output below from SwitchB, which statement is true?

27. According to industry best practices, which length is the recommended maximum for a Category 6 cable in a 10GBASE-T environment?

28. Which feature or method can you use to isolate physical layer problems on a serial link?

29. Which algorithm is used for the frame check sequence in an Ethernet frame?

30. Refer to the exhibit.

Which two statements about router R1 are true? (Choose two)

31. Drag the security features on the left to the specific security risks they help protect against on the right. (Not all features are used.

32. You are configuring a switch so that it accepts traffic from a maximum of two dynamic MAC addresses.

Drag and drop the required configuration commands on the left into the correct sequence on the right. (Not all commands are used.)

33. Which two statements about EUI-64 addressing are true? (Choose two)

34. Which statement about recovering a password on a Cisco router is true?

35. Which command can you enter to display duplicate IP addresses that the DHCP server assigns?

36. Drag and drop the benefits of a Cisco Wireless LAN controller from the left onto the correct examples on the right.

37. Which IP address can send traffic to all hosts on network 10.101.0.0/16?

38. Which feature or protocol must you enable so that the output of the show interfaces trunk command includes information about native VLAN mismatches?

39. Cisco IOS supports which QoS models?

40. Refer to the exhibit.

HostA cannot ping HostB. Assuming routing is properly configured, what is the cause of this problem?

41. Which two statements about floating static routes are true? (Choose two)

42. Which layer of the TCP/IP model manages the transmission of binary digits across an Ethernet cable?

43. Which PPP subprotocol negotiates authentication options?

44. Which two statements about single- and dual-homed links are true? (choose two)

45. Which two statements about RFC 1918 addresses are true? (Choose two)

46. Which two actions must you take to correctly configure PPPOE on a client? (Choose two)

47. Which action do you take to reset the VTP configuration revision number on a switch in VTP server mode?

48. Refer to the exhibit.

When PC 1 sends a packet to PC 2, the packet has which source and destination IP addresses when it arrives at interface Gi0/0 on router R2?

49. Which two TLVs does LLDP support? (Choose two)

50. Which three statements about the features of SNMPv2 and SNMPv3 are true? (Choose three)

51. Drag and drop the BGP components from the left onto the correct descriptions on the right.

52. Which command should you enter to view the error log in an EIGRP for IPv6 environment?

53. Which two statements correctly describe distance-vector routing protocols? (Choose two)

54. Drag each WAN access connectivity option on the left to the matching design goal on the right.

55. Which two features can you enable on a switch to capture network traffic and measure performance? (Choose two)

56. Which three statements describe the reasons large OSPF networks use a hierarchical design? (Choose three)

57. Which two features can dynamically assign IPv6 addresses? (Choose two)

58. Which two characteristics of an ICMP echo-based IP SLA are true? (Choose two)

59. Refer to the exhibit.

If all routers on this network run RIPv2, which configuration should you apply to router R3 to produce this routing table?

60. Refer to the exhibit.

Which two facts about the routing table are true? (Choose two)