Test FREE Cisco 200-125 CCNA Dumps Questions

After reading all Cisco 200-125 CCNA related exam information and topics, you will want to test your skills to confirm whether to master the following or not.

1. Have I mastered all Cisco 200-125 CCNA exam topics?
2. Have I prepared Cisco 200-125 CCNA exam well?
3. Have I mastered all 200-125 CCNA exam formats?

To be confident in taking Cisco 200-125 CCNA exam, you can test FREE Cisco 200-125 dumps questions below.

1. What is true about Ethernet? (Choose Two.)

802.2 Protocol

802.3 Protocol

10BaseThalf duplex

CSMA/CD Stops transmitting when congestion occurs

CSMA/CA Stops transmitting when congestion occurs

2. Which function does IP SLA ICMP ECHO operation perform to assist with troubleshooting

packet-loss detection

congestion detection

hop-by-hop response time

one way jitter measurement

3. What are types of IPv6 static routes? (Choose Three.)

Recursive routes

Directly connected routes

Fully specified routes

Advertised routes

Virtual links

Redistributed routes

4. How to configure RIPv2? (Choose Two.)

Enable RIP

Connect RIP to WAN interface

Enable no auto-summary

Enable authentication

5. What is the status of port-channel if LACP is misconfigured?

Forwarding

Enabled

Disabled

errdisabled

6. What is true about DTP? (Choose Three.)

Layer 2 protocol

Layer 3 protocol

Proprietary protocol

enabled by default

disabled by default

7. How to create a trunk port and allow VLAN 20? (Choose Three.)

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk allowed vlan 20

switchport trunk native vlan 20

8. What 8-bit field exists in IP packet for QoS?

Tos Field

DSCP

IP Precedence

Cos

9. What feature uses a random time to re-sent a frame?

CSMA/CA

CSMA/CD

10. Which mode is compatible with Trunk, Access, and desirable ports?

Trunk Ports

Access Ports

Dynamic Auto

Dynamic Desirable

11. If you configure syslog messages without specifying the logging trap level, which log messages will the router send?

0-4

0-5

0-6

0-2

0-1

12. Which command can you execute to set the user inactivity timer to 10 seconds?

SW1(config-line)#exec-timeout 0 10

SW1(config-line)#exec-timeout 10

SW1(config-line)#absolute-timeout 0 10

SW1(config-line)#absolute-timeout 10

13. Which standards-based First Hop Redundancy Protocol is a Cisco supported alternative to Hot Standby Router Protocol?

VRRP

GLBP

TFTP

DHCP

14. Two hosts are attached to a switch with the default configuration.
Which statement about the configuration is true?

IP routing must be enabled to allow the two hosts to communicate.

The two hosts are in the same broadcast domain.

The switch must be configured with a VLAN to allow the two hosts to communicate.

Port security prevents the hosts from connecting to the switch.

15. If a router has 3 hosts connected in one port and two other hosts connected in another port, how may broadcast domains are present on the router?

5

2

3

4

16. What are three parts of an IPv6 global unicast address? (Choose three.)

an interface ID that is used to identify the local host on the network

an interface ID that is used to identify the local network for a particular host.

a subnet ID that is used to identify networks inside of the local enterprise site

a global routing prefix that is used to identify the network portion of the address that has been provided by an ISP

a global routing prefix that is used to identify the portion of the network address provided by a local administrator

17. You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.
Which network address and subnet mask meet this requirement?

192.168.252.8 255.255.255.248

192.168.252.8 255.255.255.252

192.168.252.16 255.255.255.240

192.168.252.0 255.255.255.252

192.168.252.16 255.255.255.252

18. What parameter can be different on ports within an EtherChannel?

speed

DTP negotiation settings

trunk encapsulation

duplex

19. Which two statements about IPv6 router advertisement messages are true? (Choose two.)

They use ICMPv6 type 134.

The advertised prefix length must be 64 bits.

The advertised prefix length must be 48 bits.

They are sourced from the configured IPv6 interface address.

Their destination is always the link-local address of the neighboring node.

20. Which spanning-tree protocol rides on top of another spanning-tree protocol?

MSTP

RSTP

PVST+

Mono Spanning Tree

 Loading...

 

Any other questions plz mail us [email protected]