Read 300-370 Free Dumps to Check CCNP Wireless WITSHOOT 300-370 exam quality

Before taking 300-370 CCNP Wireless exam, you need to read Cisco 300-370 free dumps to check the quality of the study materials and make sure your will choose the great materuaks for passing Troubleshooting Cisco Wireless Enterprise Networks exam. The description of 300-370 exam shows that 300-370 exam tests a candidate’s knowledge of troubleshooting and optimizing Enterprise wireless infrastructure and related services plus the tools and methodologies needed to identify and resolve client connectivity, performance, and RF issues. Based on the description, valuable 300-370 exam dumps have been released to achieve your goal.

Read 300-370 Free Dumps to Check CCNP Wireless WITSHOOT 300-370 exam quality

1. The AP is unable to join the controller. What is the cause of this error?

Refer to the exhibit.

The controller code version is lower than the code of the AP attempting to join.

AP code is not the same as the controller and must download firmware.

AP model % not compatible with the controller code version.

The AP is riot conjured in the controller auth-list of acceptable APs.

2. Employees upgraded company issued OS devices. Which are configured to authenticate to the network using WPA2-Eniefpnse 802 lx with LEAP As a result, the devices are no longer able to authenticate Which action must the engineer do 10 resolve the issue?

Refer to the exhibit.

Redeploy the existing configuration profile.

Change LEAP certificate on the ACS server.

Reset the network settings on the devices.

Rejoin the enterprise network manually.

Deploy a new configuration profile with LEAP enabled

3. An engineer is troubleshooting non-802 11 interference and observes this output. Which type of interference signatures can be identified?

Refer to the exhibit.

one frequency hopping Bluetooth

two healthy CCK and one malformed OFDM

three broadband jammers

two strong microwave ovens and one moderate

4. Which statement about the join process of the access point is true?

Refer to the exhibit.

The time on the controller is outside of the certificates validity time interval, so the join phase failed.

The AP successfully joined the controller.

The AP moved from this controller to its primary controller.

The AP failed to join because the MAC address of the AP was not correct on the controller.

The controller rejected all discovery requests from the AP because they were not received on the management interface subnet.

5. A new wireless deployment with high AP density is experiencing high latency and connectivity issues on the 24 GHz band, despite an initial site survey done by a certified partner. Which option is the most impactful change a wireless consultant recommends?

Refer to the exhibit.

Increase the fragmentation threshold to allow larger packets over the air.

Reduce the beacon period because it reduces the RF interference.

Disable lower data rate, such as 1 Mbps and 2 Mbps.

Disable the short preamble.

Disable 80211g support to reduce interference.

6. A wireless user is experiencing connectivity issues with their Mac OS laptop. If the Mac is exhibiting the behavior of a "sticky client," how can the tech verity which AP the user is currently connected to?

Hold shift while clicking the wireless icon.

Hold option while clicking the wireless icon.

Hold control while clicking the wireless icon.

Hold command while clicking the wireless icon.

7. You have successfully configured HA and SSO using two Cisco 5508 Wireless LAN Controllers. You are able to access the Active Primary WLC but are unable to access the Secondary Standby WLC. Which two methods will allow you to access the standby unit? (Choose two.)

Via SSH to the Redundancy Management Interface.

Via Service Port Interface.

Via SSH to the Management Interface.

Via console connection.

8. DRAG DROP

Drag and drop the Layer 3 WLAN controller mutual authentication join process events on the left into the order in which they occur on the right Not all options are used.

9. An engineer has configured 802 1x for the network and all but one of the APs are passing authentication. Which configuration is causing the failure?

The AP has override global credentials checked.

The switch AAA credentials do not match what is configured on IS

The controller 802 1x supplicant credentials do not match what is configured on ISE

EAP-FAST is configured on ISE for this A

10. An engineer is troubleshooting AP join issues on a wireless infrastructure. While gathering debugs, the engineer notices that one of the commands may generate an excessive an excessive amount of data on the console. Which command causes this to occur?

debug capwap detail enable

debug capwap errors enable

debug capwap info enable

debug capwap events enable

debug capwap packet enable

debug capwap payload enable

11. Which ports require unrestricted port access for CleanAir RF spectrum analysis between the AP and Cisco Spectrum Expert?

UDP 5246 and 5247

UDP 37540 and 37550

TCP 16113 and 16114

TCP 37540 and 37550

TCP 5246 and 5247

UDP 16113and 16114

12. A network engineer is troubleshooting why EAP authentication with a client is failing. Which two commands should be used to resolve the issue? (Choose two)

debug dot1x notifications enable

debug dot1x events enable

debug arp

debug aaa detail enable

debug aaa events detail enable

13. An engineer is troubleshooting non-802 11 interference and observes this output. Which type of interference signatures can the engineer identify?

Refer to the exhibit.

microwave

DECT phone

Bluetooth

jammer

14. An engineer is troubleshooting access point placement issues and suspects that poor placement is causing connectivity issues When running the show client detail <mac> command, the engineer notices this output Which option indicates poor access point placement?

Refer to the exhibit.

excessive number of bytes sent compared to bytes received

high signal-to-noise ratio

excessive number of data retries

low ratio signal strength indicator

duplicate received packets

poor statistics for the last 90 seconds

15. An AP will be deployed to an area where DHCP Option 43 is unavailable and the WLAN engineer is unable to have DNS modifications made to support this AP. Which two actions can enable the AP to join the WLC? (Choose two)

Issue the clear capwap private-config command in the AP console.

Pre-stage or prime the AP on the same Layer 2 VLAN as the WL

Issue the capwap ap ip default-gateway WLC IP address command in the AP console.

Issue the capwap ap ip address WLC IP address command in the AP console.

Issue the capwap ap controller ip address WLC IP address command in the AP console.

16. A recently acquired Cisco Aironet 1550 series AP is unable to join the WLC. This message is observed on the AP console:

AAA Authentication Failure for UserName:CC93.1981.0035 User Type: WLAN USER

Which action must be taken for the AP to associate with the controller?

Add MAC address CC93.1981.0035 to the Security AAA AP policy Authorization List.

Authenticate the AP to the WLC from the console using an admin account on the WL

Add MAC address CC93.1981.035 to the Security AAA MAC Filtering tab.

Import the self-signed certificate of the AP to the Security:Certificate:LSC tab.

Import the self-signed certificate of the AP to the Security:Certificate:SSC tab.

17. Which feature should a network engineer enable within a mixed-client network to ensure that the legacy client operates at the best possible rates?

ClientLink

RRM

DCA

Band Select

18. A WLAN was installed at a high AP density. DTPC is lowering the transmit power of many APs too low. Which change m the DTPC transmit power threshold must be made to allow APs to globally increase AP transmit power by 3dBm?

from 70 dBm to 73 dBm

from -70 dBm to -73 dBm

from 70 dBm to 67 dBm

from -70 dBm to -67 dBm

19. Which visual cue accurately describes a characteristic of the zone of impact displayed in Cisco Prime Infrastructure?

The closer the cirlce is to blue, the more localized the impact is.

The smaller the circle, the more localized the impact is.

The larger the circle, the more severe the impact is.

The more translucent the circle is, the more localized the impact is.

20. A mobile workstation in a factory contains an AP that is configured as a workgroup bridge. When the workstation moves, it loses connectivity and disrupts operation. What can the engineer implement to minimize roaming problems?

Use 802.1X authentication.

Use Cisco Centralized Key Management for fast roaming.

Use AES for encryption.

Use the mobile station command.

 Loading...