Updated Cisco CCNP Wireless 300-365 Real Exam Dumps

1. Refer to Exhibit.

What two items need to be supported on the VoWLAN phones in order to take full advantage of this WLAN configuration? (Choose two.)

2. The customer has deployed C7960 phones with clients connected to them.

What switch feature could be enabled to distinguish IP voice traffic from client data traffic?

3. A network engineer for a college dormitory notices that student devices are filling up the SP-DB and are not allowing the shared wireless printers to be discovered.

Which feature can be used to reserve space in the SP-DB for the printers?

4. Which show command will show whether a WLAN is locally or centrally switched on a Cisco Wireless Lan Controller?

5. Refer to Exhibit.

A wireless client is connecting to FlexAPI which is currently working standalone mode.

The AAA authentication process is returning the following AVPs:

Tunnel-Private-Group-ld (81): 15

Tunnel-Medium-Type (65): IEEE-802(6)

Tunnel-Type (64): VLAN (13)

Which three behaviors will the client experience? (Choose three.)

6. A network engineer is experiencing issues enabling LAG on the WLC.

Which four characteristics should be validated to ensure LAG configuration? (Choose four.)

7. Which two options are limitations of using an AP as a workgroup bridge? (Choose two.)

8. A customer requires wireless traffic from the branch to be routed through the firewall at corporate headquarters. There is a RADIUS server in each branch location.

Which FlexConnect state should be used in this scenario?

9. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment.

What configuration issue is most likely contributing to the problem?

10. On which AP radio or radios is Cisco WGB association supported?

11. A network engineer is debugging issues with the mDNS gateway.

Which type of reply should be seen in the Wireshark capture when querying for a mDNS service in the Bonjour Cache?

12. A customer requires that an SSID is broadcasted to specific access points that use certain interfaces.

Which feature can be used to achieve this goal?

13. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking?

14. A network engineer must configure a 5 GHz network to allow for the greatest density of radios possible with the least amount of co-channel interference.

Which configuration best fulfills this requirement?

15. A customer has implemented several WLANs in an auditorium utilizing a newly dedicated WLC and is experiencing excessive channel utilization regardless of occupancy.

Which action reduces channel utilization without removing SSIDs?

16. What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller?

17. A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building.

What is the cause of the drop in video?

18. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed.

Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs?

19. An engineer used an interface group under the SSID configuration, but noticed that a test client is getting an IP assigned in a different VLAN from the DHCP server.

Which two options override the interface group configuration on the SSID? (Choose two.)

20. A customer has limited staff to manage a wireless network. The customer wants a solution that requires minimum hardware.

Which type of architecture do you propose?

21. Controllers WLC_1 and WLC_2 are in the same mobility group. A wireless client that does not have the same VLAN interface roams from WLC_1 to WLC_2.

What happens to the client roaming?

22. A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented.

How should the engineer perform the password recovery?

23. An engineer wants to configure Call Admission Control and ensure that AC is based on the capacity of the AP and considering the possible impact of other APs in the area.

Which two configuration options are required? (Choose two.)

24. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead?

25. Which network is connected by default when connecting to the unused Ethernet port of a MAP?

26. An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC.

Which typical operating mode must the engineer plan on for normal operations?

27. A customer has implemented a wireless network that requires tuning for High Density applications utilizing the RX-SOP feature. They are experiencing a high noise floor (average of -65 dBm) and expect that to decrease significantly. A sampling of radios determine that most Access Points have neighbors on the same channel at a power level of -75 dBm.

Which value should the customer use to start tuning RX-SOP?

28. A customer is implementing a massively scaled guest wireless network to support approximately 32,000 clients. For ease of administration, they have required implementing multiple interfaces defined on the WLC and mapped to a single interface group.

Which configuration meets this need?

29. DRAG DROP

Drag the QoS values from the left and drop them in the correct descending order of priority on the right.

30. A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured.

How many image transfers between the WLC and APs will occur?

31. What devices can be tracked with the Cisco Context Aware Services?

32. A network engineer is viewing the QBSS information in a packet sniff.

Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.)

33. You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ. You notice that NMSP messages are failing between the two devices.

What traffic needs to be allowed on the Firewall to ensure the MSE and WLC can communicate using NMSP?

34. A network engineer is configuring QoS and sees a DSCP value of 40. To which CoS value will this be mapped?

35. A network engineer must ensure that corporate wireless users have a better experience than guest wireless users.

Which two configurations fulfil requirement? (Choose two.)

36. A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment.

Which action must the engineer take to troubleshoot the issue?

37. Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)

38. After implementing mDNS gateway, a school’s network administrator notices that mDNS wireless printers are available over the whole network.

Which feature can the admin use to restrict the printer mDNS advertisements to the AP that the printer is joined to and adjacent APs?

39. Scenario

There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are.

Note, not all menu items, text boxes, or radio buttons are active.

What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.)

40. A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network.

What three items should the administrator check next to troubleshoot the issue? (Choose three)

41. A customer has "quiet" wireless clients that use static IP addresses.

Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.)

42. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference.

Which interface group configuration should be used?

43. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially.

What three actions should the engineer take next to optimize the configuration? (Choose Three)

44. CMX Facebook WiFi can allow access to the network before authentication.

Which two of the following options are available? (Choose two)

45. You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?

46. A customer has implemented a N+1 high availability plan in a multistory building. All APs on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors are set as primary to WLC-8.

Which two problems are likely to arise from this design? (Choose two)

47. CORRECT TEXT

Scenario

One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one of the WLCsthe other wings APs will fail over to the remaining WLC.

The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504

48. What are two functions of the RAP in a mesh network? (Choose two.)

49. A customer requires that the remote site be able to utilize local servers when the AP is in WAN-

down (standalone mode).

Which AP mode must be configured on the wireless controller?

50. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group?

51. A wireless engineer wants to enable optimized roaming for their 5GHz wireless network with these settings: -72dBm RSSI value, 25% coverage exception level percentage, and a minimum of 50 packets received.

Which two commands achieve these settings? (Choose two.)