Check Point Certified Security Master – R80 156-115.80 Exam Questions

Check Point Certified Security Master – R80 exam now is available to help you get benefits as listed:

  • Bypass wait times and fast track to a support engineer
  • Compare your policy to rules that degrade performance
  • Tune your systems to improve acceleration of traffic

Passing 156-115.80 exam can get Check Point Certified Security Master – R80 certification. How to pass? Just choose valid 156-115.80 exam questions as your preparation materials

Try Free Demo of 156-115.80 CCSM R80 Exam

1. Tom has been tasked to install Check Point R80 in a distributed deployment.

Before Tom installs the systems this way, how many machines will he need if he does NOT include a SmartConsole machine in his calculations?

2. In order to test ClusterXL failovers which command would you use on one of the ClusterXL nodes to initiate a failover?

3. Which of the following is NOT a valid “fwaccel” parameter?

4. Which of the following is not one of the relational database domains that stores the management configuration?

5. What file extension should be used with fw monitor to allow the output file to be imported and read in Wireshark?

6. Where will the usermode core files located?

7. How often will a gateway with Performance Pack running by default automatically review and distribute interface affinity between cores?

8. Which of the following features is supported in Check Point’s implementation of IPv6?

9. You verified that Performance Pack is disabled and need to distribute the affinity interfaces.

What command would you run to use static affinity to balance the interfaces between the SND cores?

10. Which command would you use to check CoreXL instances for IPv6 traffic?

11. What must be done for the “fw monitor” command to capture packets through the firewall kernel?

12. Consider a Check Point Security Gateway under high load.

What mechanism can be used to confirm that important traffic such as control connections are not dropped?

13. What is the default and maximum number of entries in the ARP Cache Table in a Check Point appliance?

14. Which kernel debug flag should you use to troubleshoot NAT connections?

15. You are working with multiple Security Gateways enforcing an extensive number of rules. To simplify security administration, which action would you choose?

16. Which type of SecureXL templates is enabled by default on Security Gateways?

17. Which one of following commands should you run to display HTTPS packet content together with kernel debug?

18. You issued the command “set ipv6-state on” in order to enable IPv6 protocol on a Security Gateway. The command was executed successfully. After reboot you notice that IPv6 protocol is not enabled.

What do you do to permanently enable IPv6 protocol?

19. Where does the translation occur with Hide NAT?

20. Fill in the blank. The tool ____________________ generates a R80 Security Gateway configuration report.

21. Which is the correct “fw monitor” syntax for creating a capture file for loading it into WireShark?

22. How many layers are incorporated in IPS detection and what are they called?

23. What is the command to check the current status of hyper-threading?

24. What occurs when Bypass Under Load activated?

25. Having a look at the output of the “fwaccel conns” command, the F flag is the indicator for a packet ______________.

26. Of how many packets consists Main Mode in Phase 1?

27. What does the command “vpn shell tunnels delete all ike” do?

28. When enabling hyper-threading on a Security Gateway, the administrator needs to make sure there is enough _______________ to support additional CoreXL Firewall instances.


 

Check Point Certified Admin (CCSA) R80.20 156-215.80 Exam Dumps
Check Point CCSA 156-215.77 exam dumps

Add a Comment

Your email address will not be published. Required fields are marked *