Achieve Success in CWNP Certified Wireless Specialist (CWS) Certification Using the Latest CWS-101 Dumps of DumpsBase

1. Which guidelines are recommended when performing a manual site survey? (Choose two.)

2. Which are relative measures of RF power? (Choose two.)

3. Which layer of the OSI model allows physical addresses to be converted to logical addresses?

4. You have a switch supporting 802.3at and you must power an AP that is 40 meters from the switch.

What can be used to provide power to the AP?

5. The throughput of a wireless LAN can be affected by or _____.

6. Which of the following MDM features allows for corporate and other applications to be distributed to mobile devices that connect to the corporate network?

7. A tablet is a single stream client with one radio and one antenna.

What 802.11 features is definitely not supported on this device?

8. Which network access method attempts to avoid collisions?

9. What is the maximum latency or delay requirement in milliseconds for many voice over IP (VoIP) devices?

10. A type of site survey that is software-based, requires minimum time on-site, and takes into consideration the attenuation value of materials such as the type of walls and doors is _____.

11. What technology may use a form of multilateration known as time difference of arrival (TDoA) to measure the difference in distance between two stations from known locations?

12. When planning for a bridge link between locations, in addition to the link distance, what requirement should be known in order to determine the antennas, settings and bridges to use?

13. You must ensure Power over Ethernet (PoE) is available for new AP installations.

What device can provide PoE power to the APs assuming it includes PoE support?

14. The IEEE 802.11 association process happens after which phase?

15. Which one of the following is an example of a real-time communications application?

16. Antennas provide an increase in RF coverage by using gain.

17. What is the term defining the number of times a cycle of an RF signal will oscillate in one second?

18. An incorrect passphrase set on a client device will result in a different preshared key that is generated for a device using WPA 2.0 as a security solution.

What will be the result of a mismatched passphrase between the client device and an access point?

19. Which wireless LAN technology can be used to obtain the highest data transfer rate possible?

20. What 802.11 PHY (Physical Layer) operates in 60 GHz?

21. When a wireless LAN device listens for beacon frames, it is participating in which phase?

22. Which is a valid logical IP address?

23. What method defines the process of connecting a device to a wireless network for the first time and allowing a user to register their device in order to gain access to the company and other network resources?

24. Non-Wi-Fi interference for an 802.11g network can be caused by and _____. (Choose two.)

25. When using a predictive modeling site survey approach, which of the following is true about manual verification?

26. What type of wireless network device is PIN-based security most commonly used with?

27. Which of the following devices is an in-line device that will inject DC voltage into the Ethernet cable?

28. You are performing a protocol analysis in order to determine potential interference from other wireless LANs in the immediate area of the site survey.

You discover several wireless LANs that can potentially cause interference with the proposed installation.

Which technology in use would not have an impact on the 802.11g wireless network you are surveying for?

29. DSSS uses which spreading code at 1 Mbps?

30. Which one of the following is an example of a multi-band device?

31. Which security solution is mandatory for client devices in order to be considered Wi-Fi Protected Setup certified?

32. What infrastructure software solution is often used to manage enterprise mobile devices?

33. What process is used in 802.11 networks to provide confidentiality?

34. An 802.11b channel is how wide in MHz?

35. The open system authentication process uses how many frames?

36. A wireless client device is showing a low receive signal strength value.

What option could improve this situation?

37. What network service is used to provide automatic Internet Protocol configuration for network client devices?

38. What technology is used to send WLAN data over a wireless medium using many subcarrier frequencies?

39. A weakness with MAC address filtering is that it allows an intruder to _____.

40. Layer 2 Tunneling Protocol commonly uses which encryption method?

41. When an AP is managed by connecting to it directly and it depends on no other device for operations, what kind of AP management system is in use?

42. When performing a manual site survey, choose the best way to identify areas that lack RF coverage.

43. Which layer of the OSI model uses physical addresses to deliver data to the destination?

44. The help desk for company XYZ received a call from a user who could not locate their company-issued smart phone device. The network administrator that was assigned to the trouble ticket is unable to remotely lock the device through the MDM software that is in use at the organization.

Which of the following would most likely cause this issue?

45. How many data bits does serial communication transmit at a time?

46. The IEEE 802.1X standard identifies the authenticator as another term for the _____ in wireless networking.

47. The IP address of a network adapter is also known as which address?

48. What may occur when an RF wave encounters an object large in relation to the wavelength during propagation?

49. An independent basic service set (IBSS) consists of how many access points?

50. When a device associates to an access point during a site survey, it is performing what type of survey?

51. At which layer of the OSI model are bits compiled into frames?

52. How many access points can be co-located without channel reuse in the same radio frequency area to maximize total system throughput while minimizing RF interference in an IEEE 802.11g network?

53. The device driver of a wireless network adapter card is _____.

54. Physical addresses on a network device are responsible for which of the following?

55. You are a network administrator and receive a call from a user stating that she cannot access the wireless LAN. The office contains 50 other users, and nobody else is complaining about the network.

What could be a potential problem that would keep this user from connecting to the access point?

56. Why would you need to know about neighbor 802.11 networks to create an effective WLAN implementation plan for a site?

57. Enterprise access points may contain which of the following features? (Choose 3.)

58. You support a wireless network for an office of five employees. The installation consists of one access point, three notebook computers, and two desktop computers.

The access point and computers in the office have wireless adapters that are Wi-Fi WPA 2.0 Certified. You want to use the highest level security possible without additional cost or administration.

Which of the following solutions would be best for this deployment? (Choose 2.)

59. Most manufacturers recommend installing a wireless IEEE 802.11n USB adapter at what point?

60. OFDM uses which communication channel width to exchange data?

61. Highly directional antennas are typically used for connectivity.

62. Which layer of the OSI model provides an interface to the user?

63. IEEE 802.11a/b/g/n devices use what type of communication?

64. Which items describe a service set identifier (SSID)? (Choose two.)

65. A well-planned and executed mobile device security strategy will help to ensure that company policy is implemented and enforced as designed and intended with every technology deployment, regardless of the device platform that is used.

Which two of the following should be considered with regard to content distribution? (Choose two.)

66. When RF passes or bends around an obstacle such as a building or column, the behavior is:

67. You are a network consultant hired to perform a manual site survey for a small office building. The wireless network to be installed will use data and voice. For backward compatibility, the customer needs to support 2.4 GHz equipment.

To provide the highest quality of service for the voice application, you recommend that the received signal strength be a minimum of for a data rate of 54 mbps.

68. IEEE 802.11a uses which PHY technology?

69. Stations (STA) operating in which two IEEE 802.11 amendments are interoperable?

70. Different types of mobile app stores are available based on what apps a user will need to download.

Which app store would be the best choice to download a custom-built app designed specifically for an organization?

71. IEEE 802.11g WLANs operate in what frequency range?

72. You are a technical support engineer and receive a call from a customer regarding a problem with their wireless network connection. The building has an ESS network with five 802.11g access points.

The customer claims that when they move from their office to a conference room using the 802.11g network they lose their connection and cannot connect to the access point in the conference room.

Which is the most likely cause for this user to lose their connection when they roam on the wireless network?

73. After the successful installation of an MDM solution, the administrator should ensure that all users of mobile devices agree to rules stated in which of the following documents?

74. How many channels are available for wireless LANs to use in the unlicensed UNII-1 band?

75. You need to perform a site survey for a small real estate office that currently has no wireless network.

Which factors must be considered as part of the site survey?

76. A newly configured wireless intrusion prevention system will _____.

77. An AP has two Ethernet wired networking ports. One (port 1) is labeled with a Power over Ethernet (PoE) indicator and the other (port 2) is not.

What is unique about port 1 when compared to port 2?

78. An azimuth chart shows which RF radiation pattern?

79. Horizontal beamwidth is to the earth's surface.

80. Why is it considered a mistake to use 160 MHz channels in most 5 GHz frequency band enterprise deployments?

81. Which frequency ranges are used in an IEEE 802.11a-compliant wireless LAN? (Choose two.)

82. Which of the following is a set of parameters or instructions that will provide a device with the ability to connect to a network and follow specific requirements or settings for the connected session?

83. When an RF signal bounces off a smooth nonabsorptive surface, the behavior is:

84. In order for a wireless client to become completely part of the basic service set, it must first _____ and then _____

85. Which are absolute measures of RF power? (Choose two.)

86. At which two layers of the OSI model does wireless LAN technology operate? (Choose two.)

87. Which of the following describe the two main parts of a computer network security policy? (Choose two.)

88. Weak or no signal at a wireless client device can be the result of _____.

89. A basic service set (BSS) consists of how many access points?

90. Access points work at which layers of the OSI model?

(Choose 2.)

91. Wireless bridges must be configured with __________and __________. (Choose 2.)

92. Which one of the following is considered a data-intensive application?

93. Which data encryption/authentication method is identified in the original IEEE 802.11 standard?

94. Without any regulatory domain taken into consideration, the 2.4 GHz frequency range allows for how many channels using 802.11b?

95. Which two of the following options are available for Wi-Fi Protected Access 2 (WPA 2.0)?

96. Which protocol is responsible for addressing and routing?

97. Which item has an effect on RF line of sight?

98. You recently installed an IEEE 802.11g wireless network in a small office. One of the employees has been complaining of poor performance and mentioned her notebook computer runs very slowly because of the access point it connects to.

What could cause this notebook computer to be performing poorly?

99. Which one of the following is a non-deprecated security solution in the 802.11 standard?

100. The physical address of a network adapter is the _____.