Dell EMC Certification E20-575 Exam Dumps

1. What is determined by setting the priority level on a Consistency Group (CG)?

2. Which RecoverPoint CLI command can be used to show a summarization of the errors and warnings for either one site or the entire RecoverPoint system?

3. When replicating a Consistency Group between clusters using XtremIO at each site that are connected through Fibre Channel, what is the maximum throughput per RPA?

4. A physical RecoverPoint cluster is connected to a single VMAX array. When running SAN diagnostics form the boxmgmt menu, what is the minimum number of WWPN can be seen in the storage ports section of the diagnostic test?

5. A storage administrator has one production site and one remote site. The administrator configured the RecoverPoint with VNX (SE) cluster at both sites. The current environment has two Consistency Groups configured with two copies each; one production copy and one remote copy. Based on the company’s growing business requirements, the administrator has been asked to keep a local copy of the production data.

Which action should occur in order to meet this requirement?

6. In Unisphere for RecoverPoint, which wizard will allow an administrator to manage and monitor all correctly accessed copies undergoing testing, failover, and production recovery?

7. A RecoverPoint administrator is adding a new user to the system using Unisphere.

Which pre-defined user is used to add a new user?

8. What occurs when Journal volumes are masked to hosts in a RecoverPoint environment?

9. In order to balance the workload of a RecoverPoint system, an administrator decided to change the primary RPA for specific Consistency Groups.

Where is this setting configured?

10. In a RecoverPoint environment, which EMC array supports Snap-based replication?

11. A storage administrator has created a new Consistency Group with a remote copy. After enabling the new group, the administrator notices several other Consistency Groups are experiencing high load alerts.

What is possible cause for the high load conditions?

12. Which parameter is used as the Locking ID for a RecoverPoint/CL license?

13. A RecoverPoint administrator needs to add a local copy to three existing Consistency Groups. The RecoverPoint system currently contains 100 Consistency Groups. Each group has one remote copy with 80 replication sets. Each cluster contains eight physical RPAs.

However, the administrator is unable to add all the local copies.

What is a cause for this issue?

14. During the Write phase of RecoverPoint replication, when does the write splitter send an acknowledgement back to the host that initiated the write?

15. What is the minimum size of a Journal when using Distributed Consistency Groups?

16. A company has a database, protected by RecoverPoint, that has become corrupted. They want to use the Recover Production wizard to repair the corruption.

Which action must be taken at the production host prior to starting the recovery?

17. Why is Image Access instantaneous when testing a copy with XtremIO arrays?

18. In order to automatically provision Journal volumes, what does RecoverPoint require when this feature is sued?

19. A RecoverPoint administrator is planning to use RecoverPoint to protect their applications. The administrator needs to protect 8192 production volumes. The RecoverPoint system has two physical clusters using VNX arrays.

What is a possible Consistency Group configuration?

20. To determine whether physical or virtual RPAs are in use on a specific cluster, what is a correct sequence of steps to determine the type of RPAs for that cluster when using Unisphere?

21. What is the recommended wait period before running the Balance Load tool?

22. An administrator ran the balance_load command on a RecoverPoint cluster during a high-load issue.

However, the administrator forgot to capture the output.

Where can the RecoverPoint Cluster Load report be located?

23. Where are incoming writes sent to during the Write phase of the RecoverPoint workflow?

24. For which type of EMC storage array(s) is the RecoverPoint/BK used for in local backups?

25. A RecoverPoint administrator is failing over a Consistency Group including two non-production copies.

What will be the replication state between the new production and former production when the administrator selects “Set Copy as Production”?

26. Which tools are listed under “System Analysis and Tools” selection of Unisphere for RecoverPoint?