Choose 300-410 Dumps (V30.02) to Prepare Smarter: Continue to Check the 300-410 Free Dumps (Part 3, Q81-Q120)

1. Refer to the exhibit.

Refer to the exhibit. an engineer is trying to get 192.168.32.100 forwarded through 10.1.1.1, but it was forwarded through 10.1.1.2.

What action forwards the packets through 10.1.1.1?

2. A network engineer is investigating a flapping (up/down) interface issue on a core switch that is synchronized to an NTP server. Log output currently does not show the time of the flap.

Which command allows the logging on the switch to show the time of the flap according to the clock on the device?

3. While troubleshooting connectivity issues to a router, these details are noticed:

✑ Standard pings to all router interfaces, including loopbacks, are successful.

✑ Data traffic is unaffected.

✑ SNMP connectivity is intermittent.

✑ SSH is either slow or disconnects frequently.

Which command must be configured first to troubleshoot this issue?

4. Refer to the exhibit.

An engineer is trying to redistribute OSPF to BGP, but not all of the routes are redistributed.

What is the reason for this issue?

5. Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route.

Which action blocks the route?

6. DRAG DROP

Drag and Drop the IPv6 First-Hop Security features from the left onto the definitions on the right.

7. Refer to Exhibit.

Which statement about redistribution from BGP into OSPF process 10 is true?

8. Which statement about MPLS LDP router ID is true?

9. While working with software images, an engineer observes that Cisco DNA Center cannot upload its software image directly from the device.

Why is the image not uploading?

10. Refer to the exhibit.

An administrator that is connected to the console does not see debug messages when remote users log in.

Which action ensures that debug messages are displayed for remote logins?

11. Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?

12. DRAG DROP

Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right.

13. Which protocol is used in a DMVPN network to map physical IP addresses to logical IP addresses?

14. Refer to the exhibit.

In which circumstance does the BGP neighbor remain in the idle condition?

15. Refer to the following output:

Router#show ip nhrp detail

10.1.1.2/8 via 10.2.1.2, Tunnel1 created 00:00:12, expire 01:59:47 TypE. dynamic, Flags: authoritative unique nat registered used NBMA address: 10.12.1.2

What does the authoritative flag mean in regards to the NHRP information?

16. Which IGPs are supported by the MPLS LDP autoconfiguration feature?

17. Refer to the exhibit.

R2 is a route reflector, and R1 and R3 are route reflector clients. The route reflector learns the route to 172.16.25.0/24 from R1, but it does not advertise to R3.

What is the reason the route is not advertised?

18. Which protocol does VRF-Lite support?

19. Users were moved from the local DHCP server to the remote corporate DHCP server. After the move, none of the users were able to use the network.

Which two issues will prevent this setup from working properly? (Choose two)

20. DRAG DROP

Drag and drop the packet types from the left onto the correct descriptions on the right.

21. DRAG DROP

Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.

22. Refer to the exhibit.

Which interface configuration must be configured on the HUB router to enable MVPN with mGRE mode?

23. What is the role of a route distinguisher via a VRF-Lite setup implementation?

24. Refer to the exhibit.

Which configuration configures a policy on R1 to forward any traffic that is sourced from the 192.168.130.0/24 network to R2?

25. Refer to the exhibit.

The ACL is placed on the inbound Gigabit 0/1 interface of the router. Host 192.168.10.10cannot SSH to host 192.168.100.10 even though the flow is permitted.

Which action resolves the issue without opening full access to this router?

26. Which statement about IPv6 ND inspection is true?

27. Refer to the exhibit.

Why is the remote NetFlow server failing to receive the NetFlow data?

28. What is an advantage of using BFD?

29. DRAG DROP

Drag and drop the MPLS terms from the left onto the correct definitions on the right.

30. Refer to the exhibit.

An engineer receives this error message when trying to access another router in-band from the serial interface connected to the console of R1.

Which configuration is needed on R1 to resolve this issue?

31. When provisioning a device in Cisco DNA Center, the engineer sees the error message “Cannot select the device. Not compatible with template”.

What is the reason for the error?

32. Refer to the exhibit.

A user cannot SSH to the router.

What action must be taken to resolve this issue?

33. Refer to the exhibit.

An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries.

Which action ensures consistency between the two times?

34. DRAG DROP

Drag and drop the SNMP attributes in Cisco IOS devices from the left onto the correct SNMPv2c or SNMPV3 categories on the right.

35. Which Cisco VPN technology can use multipoint tunnel, resulting in a single GRE tunnel interface on the hub, to support multiple connections from multiple spoke devices?

36. Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane?

37. Which two statements about redistributing EIGRP into OSPF are true? (Choose two)

38. Refer to the exhibit.

An engineer is monitoring reachability of the configured default routes to ISP1 and ISP2. The default route from ISP1 is preferred if available.

How is this issue resolved?

39. Which protocol does MPLS use to support traffic engineering?

40. Refer to the exhibit.

Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?