Pass 300-415 ENSDWI Exam First Try in 2026: Updated 300-415 Dumps (V26.03) + 300-415 Free Dumps (Part 1, Q1-Q40)

1. A bank is looking for improved customer experience for applications and reduce overhead related to compliance and security.

Which key feature or features of the Cisco SD-WAN solution will help the bank to achieve their goals?

2. Refer to the exhibit.

The ge0/0 interface connects to a 30-MB link. A network administrator wants to always have 10 MB available for high priority traffic. When lower-priority traffic busts exceed 20 MB.

Traffic should be redirected to the second WAN interface ge0/1.

Which set of configurations accomplishes this task?

A)

B)

C)

D)

3. A network administrator is configuring a tunnel interface on a branch Cisco IOS XE router to run TLOC extensions.

Which configuration will extend a TLOC over a GRE tunnel to another router in the branch?

A)

B)

C)

D)

4. A network administrator is tasked to make sure that an OMP peer session is closed after missing three consecutive keepalive messages in 3 minutes. Additionally, route updates must be sent every minute. If a WAN Edge router becomes unavailable, the peer must use last known information to forward packets for 12 hours.

Which set of configuration commands accomplishes this task?

5. DRAG DROP

Drag and drop the vManage policy configuration procedures from the left onto the correct definitions on the right.

6. Which value is verified in the certificates to confirm the identity of the physical WAN Edge device?

7. An engineer is configuring a data policy for packets that must be captured through the policy.

Which command accomplishes this task?

8. Which on-the-box security feature supported by the Cisco ISR 4451 SD-WAN device and not on vEdge?

9. Refer to exhibit.

An engineer is troubleshooting tear down of control connections even though a valid Certificate Serial Number is entered.

Which two actions resolve the Issue? (Choose two)

10. Refer to the exhibit.

What does the BFD value of 8 represent?

11. Which alarm setting is configured to monitor serious events that affect but do not shut down, the operation of a network function?

12. In which device state does the WAN edge router create control connections, but data tunnels are not created?

13. DRAG DROP

Drag and drop the route verification output from show omp tlocs from the left onto the correct explanations on the right.

14. Which VPN connects the transport-side WAN Edge interface to the underlay/WAN network?

15. Which two products that perform lifecycle management for virtual instances are supported by WAN Edge cloud routers? (Choose two)

16. Which protocol is used to measure loss latency, Jitter, and liveliness of the tunnel between WAN Edge router peers?

17. Which two mechanisms are used to guarantee the integrity of data packets in the Cisco SD-WAN architecture data plane? {Choose two)

18. Which two image formats are supported for controller codes? (Choose two)

19. Company ABC has decided to deploy the controllers using the On-Prem method.

How does the administrator upload the WAN Edge list to the vManage?

A)

B)

C)

D)

20. Which two services are critical for zero touch provisioning on-boarding? (Choose two)

21. Which SD-WAN component is configured to enforce a policy to redirect branch-to-branch traffic toward a network service such as a firewall or IPS?

22. Which configuration step is taken on vManage after WAN Edge list is uploaded?

23. Refer to the exhibit.

Which configuration change is needed to configure the tloc-extention on Branch1-Edge1?

A)

B)

C)

D)

24. An engineer wants to track tunnel characteristics within an SLA-based policy for convergence.

Which policy configuration will achieve this goal?

25. If Smart Account Sync is not used, which Cisco SD-WAN component is used to upload an authorized serial number file?

26. When the VPN membership policy is being controlled at the vSmart controller, which policy disallows VPN 1 at sites 20 and 30?

A)

B)

C)

D)

27. When a WAN Edge device joins the SD-WAN overlay, which Cisco SD-WAN components orchestrates the connection between the WAN Edge device and a vSmart controller?

28. Refer to the exhibit.

Which QoS treatment results from this configuration after the access list acl-guest is applied inbound on the vpn1 interface?

29. What is a default protocol for control plane connection?

30. Which device in the SD- WAN solution receives and categorizes event reports, and generates alarms?

31. Refer to the exhibit.

An engineer is troubleshooting an issue where vManage and vSmart have a problem establishing a connection to vBond.

Which action fixes the issue?

32. Which plane assists in the automatic onboarding of the SD-WAN routers into the SD-WAN overlay?

33. Which policy configures an application-aware routing policy under Configuration > Policies?

34. Which pathway under Monitor > Network > Select Device is used to verify service insertion configuration?

35. Which port is used for vBond under controller certificates if no alternate port is configured?

36. In an AWS cloud, which feature provision WAN Edge routers automatically in Cisco SD-WAN?

37. Which attributes are configured to uniquely Identify and represent a TLOC route?

38. Refer to the exhibit.

An engineer is configuring service chaining.

Which set of configurations is required for all traffic from Site ID 1 going toward Site ID 2 to get filtered through the firewall on the hub site?

A)

B)

C)

D)

39. Which component of the Cisco SD-WAN control plane architecture should be located in a public Internet address space and facilitates NAT-traversal?

40. When VPNs are grouped to create destination zone in Zone-Based Firewall, how many zones can a single VPN be part of?