Updated SD-WAN-Engineer Dumps (V9.02) – Great Resource to Ensure Success in Palo Alto Networks SD-WAN Engineer Exam

1. During the Zero Touch Provisioning (ZTP) process of a new ION device at a branch site, which interface ports are supported by default to request an IP address via DHCP and reach the Prisma SD-WAN controller for claiming?

2. In a Prisma SD-WAN deployment, what is the defining characteristic of a "Standard VPN" compared to a "Secure Fabric Link"?

3. Based on the HA topology image below, which two statements describe the end-state when power is removed from the ION 1200-S labeled “Active”, assuming that the ION labeled “Standby” becomes the active ION? (Choose two.)

4. A network administrator is troubleshooting a critical SaaS application, “SuperSaaSApp”, that is experiencing connectivity issues. Initially, the configured active and backup paths for the application were reported as completely down at Layer 3. The Prisma SD-WAN system attempted to route traffic for the application over an L3 failure path that was explicitly configured as a Standard VPN to Prisma Access.

However, users are still reporting a complete outage for the application and monitoring tools show application flows being dropped when attempting to use the Standard VPN L3 failure path, even though the tunnel itself appears to be up. The administrator suspects a policy misconfiguration related to how the Standard VPN path interacts with destination groups.

What is the most likely reason for flows being dropped when attempting to use the Standard VPN L3 failure path?

5. A site has two internet circuits: Circuit A with 500 Mbps capacity and Circuit B with 100 Mbps capacity.

Which path policy configuration will ensure traffic is automatically shifted from a saturated circuit to the circuit with available bandwidth?

6. Site templates are to be used for the large-scale deployment of 100 Prisma SD-WAN branch sites across different regions.

Which two statements align with the capabilities and best practices for Prisma SD-WAN site templates? (Choose two.)

7. User-ID integration is configured for a Prisma SD-WAN deployment. Branch-1 has the user-to-IP mappings available, and User-1 is mapped to IP-1.

To which two use cases can User-ID based zone-based firewall policies be applied? (Choose two.)

8. An administrator wants to configure a Path Policy that routes all "Guest Wi-Fi" traffic directly to the internet using the local broadband interface, bypassing all VPN tunnels.

Which Service & DC Group setting should be selected in the policy rule to achieve this "Direct Internet Access" (DIA) behavior?

9. Which statement is valid when integrating Prisma SD-WAN with Prisma Access remote networks?

10. By default, how many days will Prisma SD-WAN VPNs stay operational before the keys expire when an ION device loses connection with the controller?

11. What is the number and structure of Prisma SD-WAN QoS queues supported per WAN interface?

12. What are two potential causes when a secondary public circuit has been added to the branch site, but the Prisma SD-WAN tunnel is not forming to the data center? (Choose two.)

13. What is the default action for real-time media applications if link performance is poor?

14. When identifying devices for IoT classification purposes, which two methods does Prisma SD-WAN use to discover devices that are not directly connected to the branch ION? (Choose two.)

15. A network operator receives a critical SITE_CONNECTIVITY_DOWN alarm for a branch site in the Prisma SD-WAN portal.

What specific condition triggers this alarm type?

16. What is the primary function of the "CloudBlade" platform in a Prisma SD-WAN deployment when integrating with third-party services or Prisma Access?

17. A network engineer is troubleshooting a user complaint regarding "slow application performance" for an internal web application. While viewing the Flow Browser in the Prisma SD-WAN portal, the engineer notices that the Server Response Time (SRT) is consistently high (over 500ms), while the Network Transfer Time (NTT) and Round Trip Time (RTT) are low (under 50ms).

What does this data indicate about the root cause of the issue?

18. A network engineer is troubleshooting an ION device that is showing as "Offline" in the Prisma SD-WAN portal, despite the site reporting that local internet access is working. The engineer has console access to the device.

Which CLI command should be used to specifically validate the device's ability to resolve the controller's hostname and establish a secure connection to it over a specific interface?

19. A network administrator is viewing the Flow Browser to investigate a report that a specific user cannot access an internal web server. The flow entry for this traffic shows the "Flow State" as "INIT" and it remains in that state until it times out.

What does the "INIT" state indicate about the traffic flow?

20. In a data center (DC) with two ION devices, all of the remote branch Prisma SD-WAN VPNs are active only on DC ION-1.

Why are no VPNs active on DC ION-2?

21. An administrator is configuring a BGP peer on a Data Center ION to learn routes from the core switch. The goal is to have the ION learn these prefixes and then advertise them to all remote branch sites across the SD-WAN overlay.

Which setting must be configured on the BGP Peer to ensure these learned routes are redistributed into the SD-WAN fabric?

22. A network installer is at a remote branch site to deploy a new ION 3000 device. The device has been racked, cabled to the internet, and powered on. The installer has the "Claim Code" displayed on the email sent by the administrator.

When the administrator enters this Claim Code into the Prisma SD-WAN portal, what is the immediate status of the device before the configuration is fully pushed?

23. When integrating Prisma SD-WAN with Prisma Access, what is the specific role of the Service Connection (SC)?

24. An administrator is configuring a High Availability (HA) pair of ION 3000 devices at a Data Center.

Which statement accurately describes the requirement for the HA Control Interface connection between the two devices?

25. What are two requirements for implementing user/group-based path policies? (Choose two.)

26. In which modes can a Prisma SD-WAN branch be deployed?

27. Which configuration requirement must be met to allow two branch ION devices to automatically establish a direct Dynamic VPN (branch-to-branch) connection for traffic flow, bypassing the Data Center?

28. When planning a software upgrade for a large fleet of ION devices, what is the recommended best practice regarding the "Software Version" assigned in the Site Summary?

29. A multinational company is deploying Prisma SD-WAN across North America, Europe, and Asia. The data centers in the North America region have served all regions, but regional policies are now being enforced that mandate each of the regions to build their own data centers and branch sites to only connect to their respective regional data centers.

How can this regionalization be achieved so that new or existing branch sites only build tunnels to the regional DC IONs?

30. An administrator has configured a Path Policy for "ERP_Traffic". The policy allows two public internet links, "ISP-A" and "ISP-B", both marked as "Active". The Path Quality Profile (SLA) requires a latency of less than 150ms. Currently, both ISP-A and ISP-B have a latency of 40ms, well within the SLA.

How does the Prisma SD-WAN ION determine which link to use for a new flow of "ERP_Traffic" when both active paths meet the SLA requirements?