Superb NS0-163 Dumps (V12.02) Are Your Valuable Materials for Preparation: Check the Quality by Reading the NS0-163 Free Dumps (Part 2, Q41-Q80)

1. What is the maximum number of disk shelves per loop in a fabric-attached MetroCluster?

2. After you use SnapRestore to revert a volume to a specific snapshot,….

3. Node 1 in a clustered pair detects that it has lost connectivity to one of its disk shelves. Node 1 is still up, but it cannot see one of its disk shelves. However, the partner node, Node 2, can see all of Node 1s disk shelves.

Which one of the following features will cause Node 2 to monitor this error condition for a period of three minutes (by default), and then forcibly take over Node 1 if the error condition persists?

4. What console message is a good indication that the storage appliance is ready to reinstate the cluster from a previous takeover?

5. Which two supported methods would you use to restore data from a SnapVaultfor NetBackup Volume?

6. For a configuration change to be effective when using the OSSV configurator, the OSSV service must be restarted.

7. Which one of the following is not recommended as a secondary system for SnapVault?

8. You have determined that the failure to a MetroChister is a disaster.

Which step should you take?

9. When you are setting up SnapMirror, which one of the following is not a replication pre-requisite?

10. The NearStore system is not the recommended secondary storage appliance for Open System SnapVault.

11. What does it signify if the disks are "not owned" in a FAS270C appliance?

12. Which two supported methods would you use to restore data from a SnapVault for NetBackup Volume?

13. In a fabric-attached MetroCluster, hardware disk ownership by a node is determined by which two factors (Choose two.)

14. The required hardware to add SyncMirror to an existing system would be ___________.

15. Which three of the following configurations would increase data transfer rates for traditional volume SnapMirror?

16. Which OSSV package would you use to perform an OSSV unattended installation?

17. Which SyncMirror command mirrors an existing unmirrored aggregate where Data ONTAP selects the disk drives?

18. If you were troubleshooting and wanted to look at SnapMirror log files, what is the path and directory to these files?

19. The OSSV agent on the primary system listens to TCP port 10000 for all SnapVault communications.

20. The NearStore system is not the recommended secondary storage appliance for Open System SnapVault.

21. A volume is SnapMirrored hourly. You revert the volume using a snapshot that was created two days ago.

Which command continues the relationship?

22. Which tool is available on a non-NetApp primary system to assist in starting or stopping SnapVault, modifying NDMP settings, enabling debugging, and capturing trace files?

23. Which ONTAP feature will allow WORM and non-WORM volumes in the same aggregate?

24. An administrator has an ESXi cluster with VMware VMFS LUNs on an AFF system. Alter troubleshooting performance issues, the administrator determines that timeout best practices are not set on the hosts.

Which NetApp tool would apply the best practice settings?

25. Which command parameter will result in a thin-provisioned LUN?

26. Which ONTAP feature discards identical blocks and replaces them with references to a single shared block?

27. Identify the two SnapMirror commands that are entered on the destination storage appliance.

28. An administrator has presented a thinly provisioned (SCSI LUN to your ESXi host. The administrator deleted data from the datastore in ESXi. No blocks have been freed on the LUN.

What are two of the steps the administrator should use to solve this problem? (Choose two.)

29. Which two Interfaces can an administrator use to disable unused Ethernet ports on an ONTAP cluster? (Choose two.)

30. Which three tools present statistics from the Data ONTAP counter manager? (Choose three.)

31. Which option of the snap restore command allows you to specify a different directory, as long as the directory already exists?

32. Which two products can be used to administer Cloud Volumes ONTAP? (Choose two.)

33. Which one of the following statements is not true when using SnapRestore?

34. What is the maximum distance between a standard clustered pair?

35. Five minutes ago, you performed a single file SnapRestore on a large NFS file. 40% of your NFS users are now complaining about getting "stale file handles" for the file.

Which one of the following is the most likely cause of this problem, and the best procedure to correct it?

36. An administrator has an existing FlexVol accessed by Linux hosts over NFSv3. A CIFS share to the same FlexVol was created for SMB access. Windows users are unable to view the share. CIFS share permissions allow for read and write access for the Windows users.

What does the administrator need to modify to allow SMB access?

37. When using a Protection Manager policy to manage Open Systems SnapVault backups on a UNIX server, which three are valid objects to include in the data set? (Choose three.)

38. In a Fabric Attached Metro Cluster, disk ownership by a node is determined by_____________.

39. You can avoid data corruption when you issue the cf forcetakeover-d command if the remote node is

40. The SnapVault secondary system allows you to keep a separate schedule of Snapshot copies from your primary system.