Practice JNCIP-ENT JN0-647 New Questions

1. Your network provider supports multicast traffic but your provider network does not. You want to allow multicast hosts outside of your network to receive multicast traffic sourced within your network.

How would you satisfy this requirement?

2. Click the exhibit.

Referring to the exhibit, traffic handled by the s-1 scheduler is out of profile.

Assuming bandwidth is available in this scenario, which statement is correct?

3. Click the Exhibit.

Referring to the exhibit, which set of interfaces will be registered by MVRP?

4. Click the Exhibit.

You are configuring a new BGP session between router1 and router2. The session does not establish.

Referring to the exhibit, what must be done to establish this session?

5. Which router ID is correct for OSFPv3?

6. Which type of BGP is used to peer with a different autonomous system?

7. Click the Exhibit.

Referring to the exhibit, what is the minimum number of MSTP regions where the topology would be implemented?

8. Click the Exhibit.

You are asked to advertise the 1.0.0.0/8 and 1.5.5.5/32 routes to your 10.254.32.2 BGP peer.

Referring to the exhibit, which configuration change would satisfy this requirement?

9. Your campus EX9200 core devices are highly oversubscribed on bandwidth ans reporting massive dropped packets. To immediately address the issue, you decide to implement shaping on all interfaces.

Which action will accomplish?

10. What allows non-Web enabled devices to access the network on a port configured for captive portal?

11. Click the Exhibit.

Router1, in peer AS 65001, advertises routes to R2 using EBGP. R2 advertises the routes learned from R1 to R3 using IBGP. R3 is configured as a route reflector with routers R6 and R7 as clients.

Referring to the exhibit, to which routers will R3 advertise the BGP routes received from R2?

12. Click the Exhibit.

Referring to the exhibit which two statements are true? (Choose two.)

13. When configuring class of service, what would you use to allocate bandwidth to a forwarding class?

14. Click the Exhibit.

Which AS path matches the AS path regular expression shown in the exhibit?

15. A new PoE+VoIP handset was added to an EX Series device. The handset is experiencing connectivity issues. The EX Series device’s committed configuration includes the set PoE interface all telemetry command. You look at the telemetry log in the device to review power consumption and you notice entries have not been occurring for days.

What would cause telemetry logging to stop?

16. Click the Exhibit.

A customer is concerned that the route damping policy on routes with prefixes greater than/17 is allowing too many flaps to occur. The customer does not want to change the default timer.

Referring to the exhibit, which two actions would allow fewer flaps per route? (Choose two.)

17. Click the Exhibit.

Referring to the exhibit, you have EBGP peerings with both ISP1 and ISP2. You are receiving the 172.25.12.0/24, 172.25.13.0/24, 172.25.14.0/24, and 172.25.15.0/24 routes through both neighbors. You must ensure that traffic to these prefixes are load balances through both service providers. You have configured a load-balancing policy and have applied it to the forwarding table, but the prefixes are not being load balanced.

What is required to accomplish this task?

18. Which protocol is used for port-level access control and authentication?

19. Click the Exhibit.

Referring to the exhibit, you are receiving multiple routes from ISP3 through two EBGP neighbors. You must ensure that all traffic leaving R1 destined to the networks advertised by ISP3 go through ISP2.

What should you do on R1 to accomplish this task?

20. Click the Exhibit.

Referring to the exhibit, which two statements are correct? (Choose two.)

21. Which two statements are true about 802.1Z dynamic filters based on RADUIS attributes? (Choose two.)