NS0-515 Dumps – Pass NetApp Certified Implementation Engineer—SAN Specialist Exam Successfully

1. You are setting-up asynchronous mirroring between two E2860 systems

In this scenario, which two prerequisites are required to complete the setup? (choose two)

2. An orphaned volume occurs during an asynchronous mirror implementation. You must recover the orphaned volume.

In this scenario, which statement is correct?

3. Which file contains the configuration for a multipath driver for FC on Linux systems?

4. What does the CHAP secret accomplish for an E-Series system?

5. Click the exhibit button.

Referring to the exhibit, which three statements are true? (Choose three)

6. The Netapp E-Series system with a 32 Gb FC Host Interface Card (HIC) requires which type of fiber cable to connect to switches or to connect directly to hosts extending up to 100 meters?

7. What are two methods for setting the host protocol configuration on the E2800 controller with a 4-port 16Gbps FC or 10Gbps iSCSI SFP+ host interface card (HIC)? (Choose two)

8. Which three documents should be provided to the customer after the e-Series installation is complete? (choose three.)

9. An E2812 system, without expansion shelves, is configured with 12 Gb SAS host interface cards (HICS) and is directly connected to a host.

However, the host cannot access the volumes.

In this scenario, which two troubleshooting steps should you take? (Choose two)

10. To enable one-way authentication in a new iSCSI Linux implementation, which three modifications should you make in the /etc/iscsi/iscsi.conf file on the Linux host? (Choose three.)

11. An administrator is asked to migrate two DE6600 shelves into a newly deployed E5760 environment that is configured with a stack of two DE460C shelves.

In this scenario, how does the administrator complete this task?

12. A company wants the most scalable host-side connection topology for E-Series systems.

In this scenario, which FC topology would satisfy the requirement?

13. Which two errors would fail a pre-upgrade health check? (choose two.)

14. A company implemented Automatic Load Balancing (ALB). When the controller workloads are monitored, it becomes obvious that there is an imbalance and that ALB is not working correctly.

In this scenario, what are two causes of the problem? (Choose two)

15. Which data protection strategy has the most overhead capacity as a percentage of the total capacity?

16. Which two steps are required to enable multifactor authentication on an E-Series system? (Choose two)

17. Click the exhibit button.

An administrator is asked to create a 5532 GiB volume from the volume group.

Referring to the exhibit how would the administrator complete this request?

18. In which two locations would you find the WWPNs for a Windows host? (Choose two)

19. Which three factors should you consider before you install an E2860 in a data center? (Choose three)

20. When a drive fails in a Dynamic Disk Pool (DDP) with no free capacity, what happens to the data?

21. Click the exhibit button.

You ordered a NetApp E2812 Duplex 16GB 10GbE Base-T system.

Referring to the exhibit, what is the maximum number of 10GbE Base-T ports available to be used?

22. Which NetApp tool provides information on size, weight, acoustic noise, and power of NetApp E-Series systems?

23. You are helping a customer diagnose a performance issue on an E-Series storage system. You decide to measure the amount of data that is being handled over the span of an hour.

In this scenario, what are you measuring?

24. A customer has an E5760 array with a 30-drive dynamic disk Pool (DDP) that uses 800 GB SSD drives. The customer needs to expand the pool by one drive but has only a 1.6 TB SSD drive available.

In this scenario, what happens when the customer attempts to add the 1.6 TB drive to the existing pool?