New DELL EMC Campus Networking DES-5121 Exam Dumps

1. If a VRRP Master router is rebooted, what is the default behavior once it comes back online?

2. If a group of routers are running VRRP with a virtual router ID of 155, which MAC address will be used to respond to the ARP requests for the virtual IP?

3. An administrator just finished configuring a Dell EMC N-Series switch. After rebooting the switch, the administrator notices that all the configuration settings just entered are gone.

Which command did the administrator fail to enter?

4. When configuring a PBR route-map, what are the configurable "SET" options?

5. A user’s host with an IP address of 172.16.1.22/24 is attempting to FTP a file from the server with IP address 10.1.1.99; however, they are unable to connect.

Which access-list is preventing this traffic?

6. When setting up VoIP, you decide that you want to use LLDP. LLDP is enabled by default and LLDP Transmit Management Information and Notification modes are enabled.

What additional steps need to be performed?

7. After setting up the VoIP configuration, a network administrator issues the following commands with the results shown:

console# show voice vlan

Administrative Mode………………………Enable

console# show voice vlan it gi 1/0/2

Interface………………………………….Gi1/0/2

Voice VLAN Interface Mode……………Enabled

Voice VLAN ID…………………...…….10

Voice VLAN COS Overwrite……………False

Voice VLAN DSCP Value…………...….46

Voice VLAN Port Status……………...…Enabled

Voice VLAN Authentication………….…Disabled

Based on this information, what is the Layer 3 QoS value?

8. What is the IP protocol number, in decimal, assigned by IANA for VRRP?

9. What is the recommended maximum number of routers, per area, when using OSPF?

10. Refer to the Exhibit.

If Client B sends a packet to Client A, what is the highest level of the network hierarchy that the packet will transverse?

11. When configuring a Dell EMC N-Series switch for voice traffic, which settings are needed?

12. What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell EMC Campus networking switch to a Cisco VoIP phone?

13. A network administrator is troubleshooting why Host 1 cannot communicate with Host 2.

Switch-1(config)# interface tengigabitethernet 1/0/1

Switch-1(config)# switchport mode access

Switch-1(config)# switchport trunk allowed vlan 10, 20

Switch-1(config)#

Switch-1(config)# interface tengigabitethernet 1/0/3

Switch-1(config)# switchport mode access

Switch-1(config)# switchport access vlan 10

Switch-2(config)# interface tengigabitethernet 1/0/2

Switch-2(config)# switchport mode trunk

Switch-2(config)# switchport trunk allowed vlan 10, 20

Switch-2(config)#

Switch-2(config)# interface tengigabitethernet 1/0/6

Switch-2(config)# switchport mode access

Switch-2(config)# switchport access vlan 20

Based on the switch output shown in the exhibit, what is the reason for the communication issue?

14. What are key features of the Dell EMC N4064 or N4064F switches?

15. A user’s workstation has an IP phone connected to a Dell EMC N-Series switch.

What is the recommended number of VLANs that should be configured on the switch port?