Dell EMC XtremIO Specialist E20-368 Exam Questions

E20-368 exam is one of the specialist level exam, which is for Specialist – Implementation Engineer, XtremIO Solutions (DCS-IE) track. Dell EMC E20-368 exam focuses on the knowledge and activities involved in implementing XtremIO storage systems in heterogeneous virtualized open systems environments. We offer Dell EMC XtremIO Specialist E20-368 Exam Questions to help you test the knowledge and activities of requirement. Dell EMC XtremIO Specialist E20-368 Exam Questions ensure that you can pass Dell EMC E20-368 exam smoothly.

Just Test E20-368 free dumps Online First

1. While troubleshooting a host performance issue, you need to verify which ports on the XtremIO cluster a host Initiator is connected to.
Which XMCLI command should you use?

2. Which plug-in would facilitate provisioning of RDMs using vSphere Client on an XtremIO array?

3. Which plug-in would facilitate provisioning of VMFS datastores using vSphere Client on an
XtremIO array?

4. What may be required after modifying a host with the VSI plug-in?

5. What is the full list of requirements for EMC Storage Integrator?

6. What are the required hardware component types for a single X-Brick?

7. Where are the data path IO traces stored?

8. How many SSDs are in an XtremIO Starter Brick Configuration?

9. How many XMS are required for a single, four X-Brick cluster?

10. Which XtremIO component provides management for an X-Brick cluster?

11. Which resource should be used for any installation procedures performed on an XtremIO system?

12. Which NMP policy is recommended for XtremIO volumes assigned to VMware hosts?

13. How is the VM-based XMS distributed?

14. What is the default disk configuration for an XtremIO DAE?

15. Refer to the exhibit.


Where is the Storage Controller Boot and Journal disk located?

16. Refer to the exhibit.


Where are the Storage Controller trace disks located?

17. Refer to the exhibit.


Based on the XtremIO naming convention, what is the correct name for the port with the number 6?

18. Refer to the exhibit.


Based on the XtremIO naming convention, what is the correct name for the source and the destination port for number 1?

19. Refer to the exhibit, which can appear in the Inventory Pane.


What is indicated by the arrow?

20. Refer to the exhibit.


Which ports are used for external iSCSI connections?


 

New Dell EMC DES-6121 Certification Dumps
Dell EMC E20-260 VPLEX Specialist Certification Dumps

Add a Comment

Your email address will not be published. Required fields are marked *