Dell EMC PowerEdge MX Specialist Exam DES-4421 Dumps

1. A new administrator has just taken over an MX7000 Multi-Chassis Management Group and two-racks of PowerEdge servers. The previous administrator no longer works at the company and is not available. No one knows the password for the OME-M interface and the default password is not working.

What must be used to reset the password?

2. A server sled has a single mezzanine card installed in the correctly supported slot.

To which IOM fabric(s) does the sled have access?

3. When performing “A1 the Box” management, what must be done to successfully connect to the Management Module?

4. What is the number of server-facing ports and the bandwidth of each port on the MXG610s? (Choose two.)

5. What can be used as the firmware update source for OME-M within an MX chassis?

6. A company has several MX7000-systems, four FX2 solutions, one M1000e, and several PowerEdge rack servers.

Which management interface is recommended for managing this range of systems?

7. An administrator is about to perform a firmware update on an MX9116n switch OS 10 from the CLI. The latest OS 10 switch firmware image has been downloaded and their TFTP server is set up.

Upon logged in with administrator credentials on the switch, which command should be used to start the update procedure?

8. DRAG DROP

A technician is deploying a new MX7000 chassis using the Chassis Deployment Wizard.

What is the correct order o steps followed by the wizard?

9. What is a characteristic of MX7000 networking in Scalable Fabric Mode?

10. Which I/O module is supported for Fabric B?