Updated NSE6_OTS_AR-7.6 Dumps (V9.02) with 35 Practice Questions: – Mastering Fortinet NSE 6 – OT Security 7.6 Architect Exam 2026

Now you can master Fortinet NSE 6 – OT Security 7.6 Architect exam with the most updated resource. DumpsBase has updated the NSE6_OTS_AR-7.6 dumps to V9.02, offering 35 practice questions and answers, specifically engineered to align with the most recent updates to the Fortinet NSE 6 – OT Security 7.6 Architect exam objectives. Moving beyond simple question-and-answer sets, these dump questions are designed to mirror the sophisticated, multi-layered nature of the Fortinet Certified Solution Specialist track. By integrating these updated NSE6_OTS_AR-7.6 exam dumps into your routine, you aren’t just preparing for a test—you are sharpening the high-level diagnostic and architectural skills required to secure critical infrastructure in an era of rapid digital convergence.

Check the NSE6_OTS_AR-7.6 free dumps below to verify the V9.02:

1. Refer to the exhibit.





A partial OT network is shown. You want to provide the supervisor with secure remote access.

Which two features can you implement on Edge-FortiGate? (Choose two answers)

IPsec

FortiToken

SD-WAN

FSSO

2. You want FortiAnalyzer to trigger an automation stitch on a FortiGate device automatically.

What must you configure on FortiAnalyzer to enable direct communication with FortiGate? (Choose one answer)

A Fabric connector

A playbook task

The Fabric settings

An event handler

3. Refer to the exhibits.









A partial Incident Analysis page and the log details related to the event are shown. An attack is reported on your OT network. You analyze the corresponding incident.

Based on the information provided on the Incident Analysis page and the log details, which two statements are correct? (Choose two answers)

The attack uses the Modbus protocol.

The attack is mitigated.

The attack uses the IEC 104 protocol.

The event severity is high.

The target device IP address is 10.1.5.20.

4. According to the IEC 62443 standard, your security level is 4.

What is your OT environment defending against? (Choose one answer)

Intentional cyberthreats posed by skilled malicious users

An intentional attack with low resources

A syndicate of cyber extortion with extensive resources

A casual exposure

5. You want to automate some tasks in your OT network.

Which three configurations are directly available in a new basic event handler on FortiAnalyzer? (Choose three answers)

Send alert email

Create a report

Quarantine an attacker

Automatically create an incident

Automation stitch

6. Refer to the exhibit.


The Core Network Security Connectors page of the FortiGate-2 device is shown.

Which statement is correct? (Choose one answer)

FortiGate-2 serves as Fabric Root.

You must enable Security Fabric Connection on the FortiGate-2 interface.

You must configure the FortiAnalyzer settings on FortiGate-2.

FortiGate-2 is not authorized on the root FortiGate.

7. During layer 2 polling, which two pieces of information are gathered by FortiNAC to identify a device? (Choose two answers)

Where it was learned

The MAC-to-IP correlation learned

The system name learned

The time it was learned

8. For the installation of your first FortiGate device, you want to minimize the impact in your OT network. Therefore, you deploy it initially as an offline IDS.

Which two statements about this deployment are correct? (Choose two answers)

The FortiGate device acts as a network sensor.

The cybersecurity visibility increases with the security profiles.

Attacks, including zero-day attacks, are blocked.

OT traffic flows through the FortiGate device.

9. Refer to the exhibit.





Which statement about this partial Asset Identity List page is correct? (Choose one answer)

A firewall policy has an Antivirus security profile applied to it.

A firewall policy has a Virtual Patching security profile applied to it.

A firewall policy has an Intrusion Prevention security profile applied to it.

A firewall policy has an Application Control security profile applied to it.

10. Refer to the exhibits.





A partial view of the Playbook Monitor page and the corresponding playbook configuration are shown.

Based on the monitor page and the configuration of the playbook, what has triggered the Run_Report task? (Choose one answer)

An IPS_Attack_Handling event

An IPS incident creation

An Event_Trigger log

An IPS_Attack_Incident log

 Loading...