Achieve Top Scores with 300-410 Exam Dumps (V30.02): Continue to Check Our 300-410 Free Dumps (Part 2, Q41-Q80) Today

1. Which two statements about VRF-Lite configurations are true? (Choose two.)

2. Refer to the exhibit.

An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3 Fa0/0 interface. The route has changed to flow through router R2.

Which debug command is used to troubleshoot this issue?

3. What is a limitation of IPv6 RA Guard?

4. Refer to the exhibit.

A company is evaluating multiple network management system tools. Trending graphs generated by SNMP data are returned by the NMS and appear to have multiple gaps. While troubleshooting the issue, an engineer noticed the relevant output.

What solves the gaps in the graphs?

5. An engineer needs dynamic routing between two routers and is unable to establish OSPF adjacency.

The output of the show ip ospf neighbor command shows that the neighbor state is EXSTART/EXCHANGE.

Which action should be taken to resolve this issue?

6. Refer to the exhibit.

After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1.

Which action can the engineer take to solve the issue so that all the PCs are reachable?

7. Refer to the exhibit.

An administrator noticed that after a change was made on R1, the timestamps on the system logs did not match the clock.

What is the reason for this error?

8. An engineer configured a leak-map command to summarize EIGRP routes and advertise specifically loopback 0 with an IP of 10.1.1.1.255.255.255.252 along with the summary route. After finishing configuration, the customer complained not receiving summary route with specific loopback address.

Which two configurations will fix it? (Choose two.)

9. DRAG DROP

Drag and drop the operations from the left onto the locations where the operations are performed on the right.

10. Refer to the exhibit.

Users report that IP addresses cannot be acquired from the DHCP server. The DHCP server is configured as shown. About 300 total nonconcurrent users are using this DHCP server, but none of them are active for more than two hours per day.

Which action fixes the issue within the current resources?

11. Refer to the exhibits.

Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN.

Which two commands are missing? (Choose two.)

12. Which label operations are performed by a label edge router?

13. An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install.

Which command must the engineer run to correct the configuration?

14. Which two protocols can cause TCP starvation? (Choose two)

15. Which statement about route distinguishers in an MPLS network is true?

16. An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table.

What should be configured to accomplish this task?

17. Refer to the exhibit.

The output of the trace route from R5 shows a loop in the network.

Which configuration prevents this loop?

A)

B)

C)

D)

18. Which command is used to check IP SLA when an interface is suspected to receive lots of traffic with options?

19. Which list defines the contents of an MPLS label?

20. Exhibit:

BGP is flapping after the Copp policy is applied.

What are the two solutions to fix the issue? (Choose two)

21. Refer to the exhibit.

Redistribution is enabled between the routing protocols, and nowPC2 PC3, and PC4 cannot reach PC1.

What are the two solutions to fix the problem? (Choose two.)

22. A network engineer needs to verify IP SLA operations on an interface that shows on indication of excessive traffic.

Which command should the engineer use to complete this action?

23. Refer to the exhibit.

Which statement about R1 is true?

24. Refer to the exhibit.

An engineer is trying to connect to a device with SSH but cannot connect. The engineer connects by using the console and finds the displayed output when troubleshooting.

Which command must be used in configuration mode to enable SSH on the device?

25. Refer to the exhibit.

Which interface configuration must be configured on the spoke A router to enable a dynamic DMVPN tunnel with the spoke B router?

26. Refer to the exhibit.

Which two actions should be taken to access the server? (Choose two.)

27. 1.Refer to the exhibit.

Users in the branch network of 2001:db8:0:4::/64 report that they cannot access the Internet.

Which command is issued in IPv6 router EIGRP 100 configuration mode to solve this issue?

28. Refer to the exhibit.

The server for the finance department is not reachable consistently on the 200.30.40.0/24 network and after every second month it gets a new IP address.

Which two actions must be taken to resolve this Issue? (Choose two.)

29. Refer to the exhibit.

To provide reachability to network 10.1.1.0 /24 from R5, the network administrator redistributes EIGRP into OSPF on R3 but notices that R4 is now taking a ........... path through R5 to reach 10.1.1.0/24 network.

Which action fixes the issue while keeping the reachability from R5 to 10.1.1.0/24 network?

30. DRAG DROP

Drag and drop the MPLS VPN device types from me left onto the definitions on the right.

31. Refer to the exhibit.

An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen.

What is the reason for this?

32. Refer the exhibit.

Which action resolves intermittent connectivity observed with the SNMP trap packets?

33. Which statement about IPv6 RA Guard is true?

34. An engineer configured a company’s multiple area OSPF head office router and Site A cisco routers with VRF lite.

Each site router is connected to a PE router of an MPLS backbone.

After finishing both site router configurations, none of the LSA 3,4 5, and 7 are installed at Site A router.

Which configuration resolves this issue?

35. Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?

36. What is a prerequisite for configuring BFD?

37. Which option is the best for protecting CPU utilization on a device?

38. Refer to the exhibit.

Which subnet is redistributed from EIGRP to OSPF routing protocols?

39. Refer to the exhibit.

After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both spoke-to-spoke and hub were not establishing.

Which two actions resolve the issue? (Choose two.)

40. Which component of MPLS VPNs is used to extend the IP address so that an engineer is able to identify to which VPN it belongs?