350-501 SPCOR Dumps (V17.02) Are Valuable for Your Exam Preparation: Continue to Check the 350-501 Free Dumps (Part 2, Q41-Q80) Today

1. An engineer working for telecommunication company with an employee id: 3715 15 021 needs to secure the LAN network using a prefix list.

Which best practice should the engineer follow when he implements a prefix list?

2. Refer to the exhibit:

P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.

Which statement about the architecture is true?

3. When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not taking the expected path in the core.

Which command do you use to quickly check path of a TE tunnel?

4. In an MPLS network, which protocol can be used to distribute a Segment Prefix?

5. A network engineer is configuring a BGP route policy for the SUBNET prefix set. Matching traffic must be dropped, and other traffic must have its MED value set to 400 and community 4:400 added to the route.

Which configuration must an engineer apply?

6. Which configuration modifies Local Packet Transport Services hardware policies?

A)

B)

C)

D)

7. Which statement about the Cisco MPLS TE forwarding adjacency feature is true?

8. Refer to the exhibit:

If router A is the RP, which PIM mode can you configure so that devices will send multicast traffic toward the RP?

9. What does DWDM use to combine multiple optical signals?

10. You are creating new Cisco MPLS TE tunnels.

Which type of RSVP message does the headend router send to reserve bandwidth on the path to the tunnel’s router?

11. Refer to the exhibit:

With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?

12. How much must the MTU be increased when configuring the 802.1q VLAN tag?

13. You are testing the capabilities of MPLS OAM ping.

Which statement is true?

14. Refer to the exhibit:

A network operator working for service provider with an employee id 3715 15:021 applied this configuration to a router.

Which additional step should the engineer use to enable LDP?

15. After you analyze your network environment, you decide to implement a full separation model for Internet access and MPLS L3VPN services.

For which reason do you make this decision?

16. You are configuring MPLS traffic-engineering tunnels in the core.

Which two ways exist for the tunnel path across the core? (Choose two )

17. Refer to the exhibit:

A network engineer is implementing QoS services.

Which two statements about the QoS-group keyword on Cisco IOS XR 3re true? (Choose two )

18. Refer to the exhibit:

When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1.

Which factor should be the reason for this situation?

19. Refer to the exhibit:

Based on the show/ command output, which result m true after BGP session is established?

20. Refer To the exhibit:

On R1, which output does the show isis neighbors command generate?

A)

B)

C)

D)

21. Refer to the exhibit.

What is the effect of this configuration?

22. You are writing an RPL script to accept routes only from certain autonomous systems Consider this code.

RP/0/RP0/CPU0:router(config-rpl)# if as-path in (ios-regex '.*77$')

RP/0/RP0/CPU0:router(config-rpl-if)# pass

RP/0/RP0/CPU0:router(config-rpl-if)# endif

If you apply this code to BGP filters, which effect does the code have on your router?

23. Refer to the exhibit:

A network administrator wants to enhance the security for SNMP for this configuration.

Which action can the network administrator implement?

24. Which BGP attribute is used first when determining the best path?

25. Refer to the exhibit:

A network engineer is implementing a BGP protocol.

Which effect of the local-as keyword in this configuration is true?

26. Refer to the exhibit.

An engineer is configuring an administrative domain in the given multi-vendor environment with PIM-SM.

Which feature must the engineer implement so that devices will dynamically learn the RP?

27. Which two IS-IS parameters must match before two Level 2 peers can form an adjacency? (Choose two)

28. Refer to the exhibit:

Which condition must be met by the OSPF peer of router R1 before the two devices can establish communication?

29. An engineer is setting up overlapping VPNs to allow VRF ABC and XYZ to communicate with VRF CENTRAL but wants to make sure that VRF ABC and XYZ cannot communicate.

Which configuration accomplishes these objectives?

A)

B)

C)

D)

30. Refer to the exhibit:

Which statement describes this configuration?

31. Refer to the exhibit.

Which task completes the configuration?

32. Refer to the exhibit:

What is the effect of this configuration?

33. Refer to the exhibit:

What is the URL used for with REST API?

34. What do Ansible and Salt Stack have in common?

35. Refer to the exhibit.

An engineer is implementing Auto-RP and reviewing the configuration of the PE-A.

Which configuration permits Auto-RP messages to be forwarded over this interface?

36. Refer to the exhibit:

After implementing a new design for the network, a technician reviews the pictured CLI output as part of the MOP.

Which two statements describe what the technician can ascertain from the ImpNull output? (Choose two.)

37. DRAG DROP

Drag and drop the OSPF area types from the left onto the correct statements on the right

38. 1.Egress PE NAT is being used via a single centralized router to provide Internet access to L3VPN customers.

Which description of the NAT operation is true?

39. Refer to the exhibit:

R1 is connected to two service providers and is under a DDoS attack.

Which statement about this design is true if uRPF in strict mode is configured on both interfaces'?

40. A regional MPLS VPN provider operates m two regions and wants to provide MPLS L 3VPN service for a customer with two sites in these separate locations. The VPN provider approaches another organization to provide backbone carrier services so that the provider can connect to these two locations.

Which statement about this scenario is true?