350-501 Dumps (V17.02) Are Great for Your Exam Preparation: We have 350-501 Free Dumps (Part 3, Q81-Q120) Today

1. What is a role of NSO?

2. Why do Cisco MPLS TE tunnels require a link-state routing protocol?

3. Refer to the exhibit:

Export statistics received do not include the BGP next hop.

Which statement about the NetFlow export statistics is true?

4. Why do packet loops occur during the configuration of BlDlR-PIM?

5. Refer to the exhibit:

Router R1 and its peer R2 reside on the same subnet in the network, If does it make connections to R27

6. A router is configured to perform MPLS LDP graceful restart.

Which three steps are included when the RP sends an LDP initialization to a neighbor to establish an LDP session? (Choose three)

7. Refer to the exhibit:

If router RA is configured as shown, which IPv4 multicast address space does it use?

8. Refer to the exhibit.

A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network.

Which action causes the solution to fail?

9. Refer to the exhibits:

R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2 R1 message periodically.

Based on this output, which statement is true?

10. Refer to the exhibit.

What does the number 2 mean in the configuration?

11. Which utility can you use to locate MPLS faults?

12. DRAG DROP

Drag and drop the multicast concepts from the left onto the correct descriptions on the right.

13. How can a network administrator secure rest APIs?

14. Refer to the exhibit:

In which way does router R1 operate differently than router R2?

15. DRAG DROP

Drag and drop the NAT64 descriptions from the left onto the correct NAT64 types on the right.

16. Which task must be performed first to Implement BFD in an IS-IS environment?

17. Refer to the exhibit:

An engineer is preparing to implement link aggregation configuration.

Which statement al about this configuration is true?

18. Refer to the exhibit:

Which statement about this configuration is true"?

19. Refer to the exhibit:

What is significant about the number 2 in the configuration?

20. Refer to the exhibit:

Assume all other configurations are correct and the network is otherwise operating normally.

Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

21. Which protocol does a Cisco MPLS TE tunnel use to maintain paths within the core?

22. DRAG DROP

Drag and drop the functionalities from the left onto the correct target fields on the right.

23. Refer to the exhibit:

A network engineer is implementing a BGP routing policy.

Which effect of this configuration is true?

24. Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

25. Which configuration mode do you use to apply the mpls Idp graceful-restart command in IOS XE Software?

26. Which two tasks must you perform when you implement LDP NSF on your network? (Choose two.)

27. Which statement describes the advantage of a Multi-Layer control plane?

28. What are the two uses of the YANG data modeling language? (Choose two.)

29. Refer to the exhibit:

Which three outcomes occur if the prefix list is added to the neighbor? (Choose three)

30. Refer to the exhibit:

An engineer is preparing to implement data plane security configuration.

Which statement about this configuration is true?

31. What is the difference between SNMP and model-driven telemetry?

32. Refer to the exhibit:

Which effect of this configuration is true?

33. While implementing TTL security, you issue the PE(config-router-af)#neighbor 2.2.2.2 ttl-security hops 2 command.

After you issue this command, which BGP packets does the PE accept?

34. A customer of an ISP requests support to setup a BGP routing policy.

Which BGP attribute should be configured to choose specific BGP speakers as preferred exit points for the customer AS?

35. Refer to the exhibit:

Which effect of this configuration is true?

36. ASN 65001 is peering with ASN 65002 to exchange IPv6 BGP routes. All routes that originate in ASN 65001 have a standard community value of 65001:100, and ASN 65002 is allowed to advertise only 2001 :db8:aaaa::/48.

An engineer needs to update the ASN 65001 route-filtering configuration to meet these conditions:

* Looped routes into ASN 65001 and routes that have traversed 10 or more ASNs must be denied.

* Routes accepted into ASN 65001 must be assigned a community value of 65001:200.

Which configuration must the engineer apply to the ASN 65001 border router?

A)

B)

C)

D)

37. Which additional feature does MPLS DiffServ tunneling support?

38. Which service is a VNF role?

39. Refer to the exhibit:

R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed.

When the debug ip ospf hello command is issued on R1. these log messages are seen.

Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?

40. Refer to the exhibit:

Which purpose of implementing NSF with this configuration is true?