350-501 Exam Dumps (V16.02) Are the Most Current Materials for Preparation: Check 350-501 Free Dumps (Part 1, Q1-Q40) First

1. A network engineer must enable the helper router to terminate the OSPF graceful restart process if it detects any changes in the LSA.

Which command enables this feature?

2. Refer to the exhibits:

R1 and R2 are directly connected and IS-IS routing has been enabled between R1 and R2 R1 message periodically.

Based on this output, which statement is true?

3. Which utility must be used to locate MPLS faults?

4. Which statement describes the advantage of a Multi-Layer control plane?

5. Refer to the exhibit:

This configuration is being applied on an IOS XR router.

Which statement about this configuration is true?

6. Which configuration mode do you use to apply the mpls Idp graceful-restart command in IOS XE Software? MPLS

7. Why do packet loops occur during the configuration of BlDlR-PIM?

8. You are configuring MPLS traffic-engineering tunnels in the core.

Which two ways exist for the tunnel path across the core? (Choose two)

9. Refer to the exhibit:

A network engineer is implementing QoS services.

Which two statements about the QoS-group keyword on Cisco IOS XR 3re true? (Choose two)

10. Refer to the exhibit:

What is the URL used for with REST API?

11. Refer to the exhibit:

After implementing a new design for the network, a technician reviews the pictured CLI output as part of the MOP.

Which two statements describe what the technician can ascertain from the ImpNull output? (Choose two.)

12. DRAG DROP

Drag and drop the LDP features from the left onto the correct usages on the right.

13. Which statement about segment routing prefix segments is true?

14. Refer to the exhibit:

An engineer is preparing to implement link aggregation configuration.

Which statement al about this configuration is true?

15. Refer to the exhibit.

Router 4 is added to the network and must be in the same area as router 1.

Which NET should the engineer assign?

16. DRAG DROP

Drag and drop the OSPF area types from the left onto the correct statements on the right

17. Refer to the exhibit:

Which effect of this configuration is true?

18. Refer to the exhibit:

Router 1 was experiencing a DDoS attack that was traced to interface gjgabitethernet0/1.

Which statement about this configuration is true?

19. Refer To the exhibit:

On R1, which output does the show isis neighbors command generate?

A)

B)

C)

D)

20. Refer to the exhibit:

Which statement about the neighbor statements for 192.168.1.1 is true?

21. Refer to the exhibit:

A network operator working for service provider with an employee id 3715 15:021 applied this configuration to a router.

Which additional step should the engineer use to enable LDP?

22. Refer to the exhibit:

A network engineer is implementing a BGP protocol.

Which effect of the local-as keyword in this configuration is true?

23. Refer to the exhibit:

With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?

24. Refer to the exhibit:

R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1. these log messages are seen.

Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?

25. How can shared services in an MPLS Layer 3 VPN provide Internet access to the customers of a central service provider?

26. DRAG DROP

Drag and drop the NAT64 descriptions from the left onto the correct NAT64 types on the right.

27. Which two tasks must you perform when you implement LDP NSF on your network? (Choose two.)

28. Refer to the exhibit:

Which command is used to complete this configuration for QoS class-based marking?

29. Refer to the exhibit.

What is the effect of this configuration?

30. Refer to the exhibit:

Which statement describes the effect of this configuration?

31. Which BGP attribute is used first when determining the best path?

32. Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?

33. Refer to the exhibit.

Router 1 is missing the route for the router 2 loopback 0.

What should the engineer change to fix the problem?

34. Which two IS-IS parameters must match before two Level 2 peers can form an adjacency? (Choose two)

35. Which regular expression query modifier function indicates the start of a string?

36. Refer to the exhibit.

Which task completes the configuration?

37. Which three OSPF parameters must match before two devices can establish an OSPF adjacency? (Choose three.)

38. Refer to the exhibit:

P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.

Which statement about the architecture is true?

39. Refer to the exhibit.

While troubleshooting the network, a network operator with an employee id: 3812:12:993 is trying to ping XR1.

Which result should the operator expect when trying to ping to an XR1 local address?

40. Refer to the exhibit:

Which statement about this configuration is true"?