300-410 Updated Dumps (V31.02) – Sharing 300-410 Free Dumps (Part 1, Q1-Q40) Online to Help You Access Quality

Are you looking for reliable study materials to prepare for your Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) 300-410 exam? We have updated the Cisco 300-410 dumps to V31.02, offering you 640 practice questions and answers for exam preparation. These Q&As ensure you stay ahead of the competition. With a convenient PDF format, you can study anytime, anywhere—whether reviewing key concepts on your phone or practicing full exam simulations on your laptop. Combined with regularly updated content and verified accuracy, these 300-410 dumps (V31.02) eliminate outdated information and reduce uncertainty, allowing you to focus your time on what truly matters. With DumpsBase, you are not just preparing for the Cisco ENARSI 300-410 exam—you are building the confidence, skills, and strategy needed to pass the exam on your first attempt.

Sharing Cisco 300-410 free dumps (Part 1, Q1-Q40) of V31.02 below to help you access quality first:

1. Refer to the exhibit.





An engineer is trying to configure local authentication on the console line, but the device is trying to authenticate using TACACS+.

Which action produces the desired configuration?
2. An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table.

What should be configured to accomplish this task?
3. DRAG DROP

Drag and drop the MPLS VPN concepts from the left onto the correct descriptions on the right.


4. Which is statement about IPv6 inspection is true?
5. Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane?
6. Refer to the exhibits.









Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN.

Which two commands are missing? (Choose two.)
7. Which statement about route distinguishers in an MPLS network is true?
8. Refer to the exhibit.





A junior engineer updated a branch router configuration. Immediately after the change, the engineer receives calls from the help desk that branch personnel cannot reach any network destinations.

Which configuration restores service and continues to block 10.1.1.100/32?
9. Refer to the exhibit.









After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both spoke-to-spoke and hub were not establishing.

Which two actions resolve the issue? (Choose two.)
10. DRAG DROP

Refer to the exhibit.


Drag and drop the credentials from the left onto the remote login information on the right to resolve a failed login attempt to vtys. Not all credentials are uf SLA by defining frequency and scheduling Sed


11. Which statement about IPv6 RA Guard is true?
12. Which two methods use IPsec to provide secure connectivity from the branch office to the headquarters office? (Choose two.)
13. Refer to the exhibit.





Refer to the exhibit. an engineer is trying to get 192.168.32.100 forwarded through 10.1.1.1, but it was forwarded through 10.1.1.2.

What action forwards the packets through 10.1.1.1?
14. Exhibit:





BGP is flapping after the Copp policy is applied.

What are the two solutions to fix the issue? (Choose two)
15. Refer to the exhibit.





An engineer configures a static route on a router, but when the engineer checks the route to the destination, a different next hop is chosen.

What is the reason for this?
16. Refer to the exhibit.





Which configuration configures a policy on R1 to forward any traffic that is sourced from the 192.168.130.0/24 network to R2?







17. Which protocol is used in a DMVPN network to map physical IP addresses to logical IP addresses?
18. DRAG DROP

Drag and drop the DHCP messages from the left onto the correct uses on the right.


19. Refer to the exhibit.





An engineer is trying to generate a summary route in OSPF for network 10.0.0.0/8, but the summary route does not show up in the routing table.

Why is the summary route missing?
20. Refer to the exhibit.





An IP SLA was configured on router R1 that allows the default route to be modified in the event that Fa0/0 loses reachability with the router R3 Fa0/0 interface. The route has changed to flow through router R2.

Which debug command is used to troubleshoot this issue?
21. Refer to the exhibit.





Why is the remote NetFlow server failing to receive the NetFlow data?
22. Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family

configuration?
23. Which two protocols can cause TCP starvation? (Choose two)
24. Which two statements about redistributing EIGRP into OSPF are true? (Choose two)
25. Which SNMP verification command shows the encryption and authentication protocols that are used in SNMPV3?
26. Which security feature can protect DMVPN tunnels?
27. Which Cisco VPN technology can use multipoint tunnel, resulting in a single GRE tunnel interface on the hub, to support multiple connections from multiple spoke devices?
28. DRAG DROP

Drag and Drop the IPv6 First-Hop Security features from the left onto the definitions on the right.


29. Refer to the exhibit.





Which two actions should be taken to access the server? (Choose two.)
30. Refer to the exhibit.





Network operations cannot read or write any configuration on the device with this configuration from the operations subnet.

Which two configurations fix the issue? (Choose two.)
31. Refer to the exhibit.





A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there ............ a backup link over link A toward the ASN.

Which BGP configuration on R1 accomplishes this goal?

A)





B)





C)





D)



32. DRAG DROP

Drag and drop the MPLS terms from the left onto the correct definitions on the right.


33. During the maintenance window an administrator accidentally deleted the Telnet-related configuration that permits a Telnet connection from the inside network (Eth0/0) to the outside of the networking between Friday C Sunday night hours only.

Which configuration resolves the issue?
34. Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?
35. Which protocol does VRF-Lite support?
36. Which transport layer protocol is used to form LDP sessions?
37. Refer to the exhibit.





What is the result of applying this configuration?
38. Refer to the exhibit.





Why is user authentication being rejected?
39. Refer to the exhibit.





An engineer has configured DMVPN on a spoke router.

What is the WAN IP address of another spoke router within the DMVPN network?
40. What does IPv6 Source Guard utilize to determine if IPv6 source addresses should be forwarded?

 

350-401 ENCOR Dumps Updated (V40.02) for Preparation - Check 350-401 Free Dumps (Part 1, Q1-Q40) First
Tags: