Verified D-PDC-DY-23 Exam Dumps – An Excellent Resource for the Dell PowerSwitch Data Center Deploy 2023 Exam Preparation

1. Refer to the exhibit.

Which configuration will allow S1 to ping S2’s Lo0 address?

2. When installing OS10 on a switch from a USB drive, what format is used for the file system?

3. What do bridge protocol data units provide?

4. A network administrator has to configure a virtual IP address using VRRP on interface VLAN 100 within OS10.

What are the correct steps to accomplish this?

5. What are mandatory LLDPDU TLV's?

6. What is the function of UFD?

7. Using the MAC 8c-ec-4b-5b-61-9d, what is a valid EUI-64 link local address?

8. In a PIM Sparse Mode (PIM-SM) based multicast topology, what function does the Rendezvous Point provide?

9. What does the command aaa authentication login default group radius local do?

10. What is the default PIM-SSM IP range?

11. A network administrator wants to limit the amount of bandwidth that video traffic can consume.

Which type of policy map should be used?

12. How are ACLs processed?

13. What is a benefit of multicast over unicast and broadcast communication

14. What must be done before configuring any routing protocol in a VRF instance?

15. Refer to the exhibit.

Which three commands are used when deploying an automated Leaf and Spine topology using SFS? (Select 3)

16. What is the maximum number of LLDP neighbors supported per system with OS10?

17. Which best describes traffic flow in a campus network environment?

18. Which command mode allows configuration of switches L2 and L3 interfaces?

19. A network administrator has configured Policy-based-Routing and applied it on interface ethernet 1/1/3.

What command can be used to verify that the policy is applied?

20. Which switch mode is used to manage files and display switch information?

21. Two (2) Dell EMC Networking OS10 switches in a VLT configuration need to be upgraded.

How will the reload of these switches proceed to result in the default initial state?

22. What is the default transmission interval of an LLDPDU in SmartFabric OS10?

23. Which multicast address is used by all OSPF routers?

24. When configuring a vrf instance for the management interface that has been in use, what step must be done first to configure it?

25. Refer to the exhibit.

Where is the rendezvous point for the group 239.255.255.250?

26. What does an ABR do with a Type 7 LSA it receives from an attached NSSA?

27. Which IEEE standard defines the Multiple Spanning Tree Protocol?

28. A network administrator wants to configure a timing protocol with these requirements:

- Hardware time stamping to achieve sub microsecond synchronization.

- Master IP address: 192.168.1.100.

- Use interface Ethernet 1/1/1 to enable timing protocol.

Which configuration supports the requirements?

29. When using Policy-Based Routing, what is a valid action?

30. What type of network in a Data Center flattens the core and aggregation layers into a single tier?

31. In a Layer 3 Leaf-Spine topology what can be used to move Layer 2 traffic between racks?

32. What is an advantage of UFD?

33. Which Ethernet interface speeds do Dell Networking OS10 switches support?

34. Refer to the exhibit.

No static routing has been configured. For iBGP loopback-based peering, which statement is correct?

35. A network administrator must restrict packets that are destined to the CPU of an OS10 switch.

How do they accomplish this?

36. What are the correct commands that configure the DHCP lease from pool DC1 to never expire?

37. A network administrator is implementing VRRP on a switch and has configured VLAN 10 to use a matching VRRP group ID 10.

Which two commands indicate default VRRP settings? (Select 2)

38. What is the valid range of VLAN IDs for Dell EMC Networking OS10 switches?

39. ACLs have which two actions?

40. Refer to the exhibit:

From S1, a ping to the host address of 192.168.37.3 is not successful. The routing table on S1 shows three directly connected networks (including the Lo0 network of S1). Network 192.168.34.0/24 and the Lo0 networks of S2 and S3 are the only OSPF-learned networks in the routing table. The system on the 192.168.37.0/24 network can ping S3.

Which command offers a solution to the inability to ping the host address from S1?

41. A network administrator is designing a Layer 2 topology and requires separate spanning- tree roots to avoid having a given port blocked for all instances.

Which spanning-tree protocols will meet this need?

42. What configuration must be common on iBGP neighbors to form an iBGP adjacency?

43. Refer to the exhibit.

The output shown is from which command?

44. A router must be configured to allow multiple multicast servers for the same group to be presented only to ports where active listeners reside. Each listener may exclude non-preferred servers.

What is the minimum multicast configuration level required on the router?

45. A router needs to be configured to allow multiple multicast servers for the same group to be presented only to ports where active listeners reside. Each listener may exclude non-preferred servers.

What is the minimum multicast configuration level required on the router?

46. How many VRRP groups can be configured on a VRRP router?

47. ACL's have which two (2) actions?

48. Multicast flood restrict is a feature enabled by default on OS10 switches to ensure that no traffic drop occurs.

What is a recommended configuration step for its implementation?

49. What is the range of values that can be used when using the vlt-port-channel command?

50. A network administrator must configure separate rendezvous points for multicast groups 232.0.0.100 and 225.0.0.100.

Which commands are used for this configuration?

51. A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports.

What caused the issue?

52. Refer to the exhibit.

What will happen when a network administrator enters the shutdown command?

53. Match the IGMP versions and features in the source column to the feature or version where they first appeared. There are more packet descriptions than IGMP versions.

54. What is the purpose of the DHCP Relay Agent?

55. What is an attribute of OS10 Enterprise Edition?

56. A network administrator is troubleshooting a PBR implementation and needs to know how many packets have matched the route-map criteria.

How do they view this information in OS10?

57. What is a benefit of adding a virtual router partition in OS10?

58. When configuring VRRP in tandem with VLT, what is the default VRRP mode?

59. What is an advantage of running LLDP?

60. Interface Ethernet 1/1/3 has been configured with an IP address, and the interface is UP.

How does the routing table present the associated network?

61. You have been asked to examine a BGP configuration for a co-worker who is having difficulty establishing BGP peering. The address shown is that of the neighbor's Lo0 interface.

Given the configuration shown, what would be your recommendation?

S3(config-router-bgp-65042)# neighbor 192.168.32.1

S3(config-router-neighbor)# remote-as 65042

62. The VLAN tag is located between which fields in the Ethernet frame?

63. What is a valid OS10 iBGP configuration?

64. Which OSPF router is responsible for originating Network Link State Advertisements?

65. How are BGP neighbor relationships created?

66. How does a DHCP Client make a request to a DHCP server following an offer?

67. Which router types are contained in a single-area OSPF implementation?

68. What does the stratum value of 16 mean on an NTP server?

69. A network administrator has recently configured eBGP to use source addressing from its loopback interfaces. Customers later report that eBGP routes are not being learned.

What could be the cause of this issue?

70. Which two options describe the differences between Layer 2 and Layer 3 QoS? (Select 2)

71. With what feature is the downstream ethernet 1/1/9:1-1/1/9:4 command associated?

72. What is the size of the VLAN tag in an Ethernet frame?

73. Which two commands display if a port is currently active in a VLAN?

74. Refer to the exhibit:

What happens when a network administrator enters the shutdown command?

75. Which LSA type contains information about routes redistributed into OSPF?

76. In an NSSA, which type of LSA is used for redistribution?

77. What are the benefits associated with a multiple-area OSPF implementation?

78. A network administrator must configure a virtual IP address using VRRP on interface VLAN 100 within OS10.

What are the correct steps to accomplish this?

79. Which multicast address do all OSPF routers use?

80. In a PIM Sparse Mode based multicast topology, what role does the Rendezvous Point provide?