Updated Fortinet NSE 7 – Enterprise Firewall 6.4 Exam Dumps NSE7_EFW-6.4 Dumps Questions

1. View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.

Which statements about this debug output are correct? (Choose two.)

2. Refer to the exhibit, which contains the partial output of a diagnose command.

Based on the output, which two statements are correct? (Choose two.)

3. Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

4. Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.

diagnose debug authd fsso list ―FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB.

What should the administrator check?

5. View the IPS exit log, and then answer the question below.

# diagnose test application ipsmonitor 3

ipsengine exit log”

pid = 93 (cfg), duration = 5605322 (s) at Wed Apr19 09:57:26 2017

code = 11, reason: manual

What is the status of IPS on this FortiGate?

6. View the exhibit, which contains the output of diagnose sys session stat, and then answer the question below.

Which statements are correct regarding the output shown? (Choose two.)

7. An administrator has configured the following CLI script on FortiManager, which failed to apply any changes to the managed device after being executed.

Why didn’t the script make any changes to the managed device?

8. View the exhibit, which contains the output of a debug command, and then answer the question below.

Which of the following statements about the exhibit are true? (Choose two.)

9. What configuration changes can reduce the memory utilization in a FortiGate? (Choose two.)

10. Which statement about memory conserve mode is true?

11. The CLI command set intelligent-mode <enable | disable> controls the IPS engine’s adaptive scanning behavior .

Which of the following statements describes IPS adaptive scanning?

12. Which two statements about the Security Fabric are true? (Choose two.)

13. Which of the following statements are correct regarding application layer test commands? (Choose two.)

14. View the exhibit, which contains the output of a diagnose command, and the answer the question below.

Which statements are true regarding the Weight value?

15. What is the purpose of an internal segmentation firewall (ISFW)?

16. View the global IPS configuration, and then answer the question below.

Which of the following statements is true regarding this configuration?

17. Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the output in the exhibit? (Choose two.)

18. A FortiGate device has the following LDAP configuration:

The LDAP user student cannot authenticate.

The exhibit shows the output of the authentication real time debug while testing the student account:

Based on the above output, what FortiGate LDAP settings must the administer check? (Choose two.)

19. View the exhibit, which contains the output of get sys ha status, and then answer the question below.

Which statements are correct regarding the output? (Choose two.)

20. View the exhibit, which contains the output of a web diagnose command, and then answer the question below.

Which one of the following statements explains why the cache statistics are all zeros?

21. Examine the following partial output from two system debug commands; then answer the question below.

Which of the following statements are true regarding the above outputs? (Choose two.)

22. Refer to the exhibit, which contains the partial output of the get vpn ipsec tunnel details command.

Based on the output, which two statements are correct? (Choose two.)

23. View the exhibit, which contains the output of a debug command, and then answer the question below.

Which one of the following statements about this FortiGate is correct?

24. Examine the following partial outputs from two routing debug commands; then answer the question below:

Why the default route using port2 is not displayed in the output of the second command?

25. View the exhibit, which contains an entry in the session table, and then answer the question below.

Which one of the following statements is true regarding FortiGate’s inspection of this session?

26. An administrator wants to capture ESP traffic between two FortiGates using the built-in sniffer.

If the administrator knows that there is no NAT device located between both FortiGates, what command should the administrator execute?

27. Examine the output of the ‘diagnose ips anomaly list’ command shown in the exhibit; then answer the question below.

Which IP addresses are included in the output of this command?

28. Which of the following conditions must be met for a static route to be active in the routing table? (Choose three.)

29. Which two statements about FortiManager is true when it is deployed as a local FDS? (Choose two.)

30. A FortiGate's portl is connected to a private network. Its port2 is connected to the Internet. Explicit web proxy is enabled in port1 and only explicit web proxy users can access the Internet. Web cache is NOT enabled. An internal web proxy user is downloading a file from the Internet via HTTP .

Which statements are true regarding the two entries in the FortiGate session table related with this traffic? (Choose two.)

31. Examine the output of the 'diagnose debug rating' command shown in the exhibit; then answer the question below.

Which statement are true regarding the output in the exhibit? (Choose two.)

32. View the exhibit, which contains the output of a diagnose command, and then answer the question below.

What statements are correct regarding the output? (Choose two.)

33. Refer to the exhibit, which shows a FortiGate configuration.

An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however, the web filter is not inspecting any traffic that is passing through the policy.

What must the administrator change to fix the issue?

34. What events are recorded in the crashlogs of a FortiGate device? (Choose two.)

35. Examine the partial output from two web filter debug commands; then answer the question below:

Based on the above outputs, which is the FortiGuard web filter category for the web site www.fgt99.com?

36. Which of the following statements is true regarding a FortiGate configured as an explicit web proxy?

37. Refer to the exhibit, which contains partial output from an IKE real-time debug.

Based on the debug output, which phase 1 setting is enabled in the configuration of this VPN?

38. An administrator has configured a dial-up IPsec VPN with one phase 2, extended authentication (XAuth) and IKE mode configuration.

The administrator has also enabled the IKE real time debug:

diagnose debug application ike-1

diagnose debug enable

In which order is each step and phase displayed in the debug output each time a new dial-up user is connecting to the VPN?

39. Which statements about bulk configuration changes using FortiManager CLI scripts are correct? (Choose two.)

40. Examine the output from the ‘diagnose vpn tunnel list’ command shown in the exhibit; then answer the question below.

Which command can be used to sniffer the ESP traffic for the VPN DialUP_0?