Master the Huawei HCIA-Datacom V2.0: Your Guide to the Latest H12-811_V2.0-ENU Exam Dumps (V8.02)

The Huawei HCIA-Datacom V1.0 is still available, but will be offline on September 30, 2026. It is highly recommended to register for the Huawei HCIA-Datacom V2.0 certification exam. The latest H12-811_V2.0-ENU exam dumps (V8.02) from DumpsBase are available to be the most effective way to align your study sessions with the real exam experience. We have 60 practice questions in V8.02, which help you achieve your datacom certification goal, proving that you have systematically understood and mastered the basic information, knowledge, and related technologies. These Huawei H12-811_V2.0-ENU exam dumps (V8.02) ensure you build confidence by familiarizing yourself with the exact Multiple-Choice Question (MCQ) style before test day. Start with DumpsBase. By choosing these structured, expertly reviewed H12-811_V2.0-ENU dump questions, you ensure that every study hour brings you closer to a guaranteed pass.

Check H12-811_V2.0-ENU free dumps below to verify the quality first:

1. After the root bridge is elected on an STP network, which of the following parameters may be compared by ports on non-root bridge nodes to elect the root port? (Select all that apply)
2. In TCP/IP-based end-to-end communication, only the source and destination hosts process the header information added at the transport layer. Routers along the path will definitely not process this information.
3. The figure shows the simplified topology of an enterprise campus network. On this network, the aging time of dynamic MAC address entries on switches is 300 seconds.

The administrator connects PC1 to GE1/0/1 of SW1 and successfully pings the IP address of PC2 from PC1. Then, the administrator disconnects the Ethernet cable of PC1 from GE1/0/1 of SW1, immediately connects the cable to GE1/0/2 of SW1, and pings the IP address of PC2 from PC1.

Which of the following operations does SW1

perform after receiving a data frame from PC1 when PC1 is connected to GE1/0/2 of SW1?



4. The administrator configures an Eth-Trunk in LACP mode between two switches, and sets the maximum number of active links in the Eth-Trunk to 3 and the number of remaining standby links to 1. If one of the active links fails, the two switches automatically adjust the number of active links to 2 through negotiation, and the standby link remains in the standby state.
5. On an STP network, an administrator wants SW2 to be elected as the root bridge.

Which of the following methods can be used to achieve this goal?



6. In the STP topology shown in the figure, all links have the same path cost, and SW1 is the root bridge.

Which of the following ports will become designated ports? (Select all that apply)



7. The essence of communication is the transmission and exchange of information between two or more points. The three elements of communication are the sender, content, and transmission channel of the information. The receiver of the information is not included among these elements.
8. If the neighbor relationship between R1 and R2 has reached the Full state in OSPF, which of the following statements are true? (Select all that apply)
9. In the figure, both PC1 and PC2 belong to VLAN 10. Interface GE1/0/1 on SW1 is a trunk interface with the default PVID, and interface GE1/0/2 on SW1 is an access interface in VLAN 10.

Which of the following statements are true about the forwarding of data frames between PC1 and PC2? (Select all that apply)



10. On a switched network where STP is enabled on all devices, when a downstream device detects a topology change, it continuously sends configuration BPDUs to the upstream device until the root bridge is informed of the topology change.
11. On the network shown in the figure, all switches run STP. All links have a path cost of 20, and SW1 is the root bridge.

What is the root path cost (RPC) of SW4?
12. The undo command can be used in the CLI of a Huawei device to restore default settings, disable functions, or delete configurations.

Which of the following are correct undo commands? (Select all that apply)
13. In the figure, a web client sends an HTTP request to a web server, and the router in between performs operations on the HTTP request.

Which of the following statements are false about the router’s operations? (Select all that apply)



14. On the network shown in the figure, R1 serves as the gateway for PC2 and PC3, and directly connects to S1 through a physical link. GE1/0/1 on S1 is configured as a trunk interface and permits traffic of VLANs 2 and 3. Its PVID retains the default value.

Which of the following statements are true if PC2 and PC3 can communicate with each other? (Select all that apply)



15. On the network shown in the figure, GE1/0/1 and GE1/0/2 of SW1 are access interfaces, and their PVIDs are VLAN 2 and VLAN 3 respectively. GE1/0/1 of SW2 is also an access interface, and its PVID is VLAN 4.





Which of the following configurations on SW1 and SW2 can ensure that data packets sent from PC1 and PC2 can reach PC3?
16. In the figure, a TCP connection has been established between PC1 and PC2.





After PC1 sends a data segment to PC2, which of the following is the acknowledgment number in the packet returned by PC2?
17. You can enter a question mark (?) in the CLI of a Huawei switch to obtain online help.

Which of the following statements is true about the meaning of in the output of the command sysname SW1?
18. Four links between two switches establish an Eth-Trunk in manual mode, and the bandwidth of each link is 1 Gbit/s. One of the links fails.

Which of the following statements are true about this scenario? (Select all that apply)
19. On the switched network shown in the figure, STP is enabled on all devices. SW1 is the root bridge. The port costs are shown in the figure. Other parameters retain the default values.

After the network is stable, which of the following paths is used by SW1 to send traffic to SW4?



20. On the network shown in the figure, the administrator creates Eth-Trunk 1 in manual mode on SW1 and SW2, and adds GE1/0/1 and GE1/0/2 on both switches to the Eth-Trunk. After the administrator runs the display interface brief command on SW1, the administrator finds that GE1/0/1 is Up and GE1/0/2 is Down.

Which of the following statements is true about this scenario?




 

Huawei H12-111_V3.0-ENU Practice Questions (V8.02) - A Highly Structured and Exam-focused Resource for HCIA-IoT V3.0 Exam Preparation

Add a Comment

Your email address will not be published. Required fields are marked *