Latest FCSS_NST_SE-7.6 Dumps (V10.02) – The Most Current Materials for Fortinet NSE 6 – Network Security 7.6 Support Engineer Exam Success 2026

1. Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

2. In IKEv2, which exchange establishes the first CHILD_SA?

3. Refer to the exhibit, which shows a partial output of the fssod daemon real-time debug command.

What two conclusions can you draw from the output? (Choose two.)

4. Refer to the exhibit, which shows a session entry.

Which statement about this session is true?

5. Which two statements about Security Fabric communications are true? (Choose two.)

6. Refer to the exhibit, which shows a truncated output of a real-time LDAP debug.

What two conclusions can you draw from the output? (Choose two.)

7. Exhibit.

Refer to the exhibit, which shows the output of diagnose automation test.

What can you observe from the output? (Choose two.)

8. Which authentication option can you not configure under config user radius on FortiOS?

9. Which exchange lakes care of DoS protection in IKEv2?

10. In which two slates is a given session categorized as ephemeral? (Choose two.)

11. Exhibit 1.

Exhibit 2.

Refer to the exhibits, which show the configuration on FortiGate and partial internet session information from a user on the internal network.

An administrator would like to lest session failover between the two service provider connections.

Which two changes must the administrator make to force this existing session to immediately start using the other interface? (Choose two.)

12. Exhibit.

Refer to the exhibit, which shows a FortiGate configuration.

An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however the web filter is not inspecting any traffic that is passing through the policy.

What must the administrator do to fix the issue?

13. An administrator wants to capture encrypted phase 2 traffic between two FotiGate devices using the built-in sniffer.

If the administrator knows that there Is no NAT device located between both FortiGate devices, which command should the administrator run?

14. Refer to the exhibit, which shows the output of a BGP debug command.

What can you conclude about the router in this scenario?

15. Exhibit.

Refer to the exhibit, which shows the output of a session.

Which two statements are true? (Choose Iwo.)

16. Which two statements about an auxiliary session ate true? (Choose two.)

17. Refer to the exhibit, which contains the output of diagnose vpn tunnel list.

Which command will capture ESP traffic for the VPN named DialUp_0?

18. Refer to the exhibit, which shows the output of a policy route table entry.

Which type of policy route does the output show?

19. Refer to the exhibits.

An administrator Is expecting to receive advertised route 8.8.8.8/32 from FGT-A. On FGT-B, they confirm that the route is being advertised and received, however, the route is not being injected into the routing table.

What is the most likely cause of this issue?

20. Exhibit.

Refer to the exhibit, which shows the output of get system ha status.

NGFW-1 and NGFW-2 have been up for a week.

Which two statements about the output are true? (Choose two.)

21. Which two statements are true regarding heartbeat messages sent from an FSSO collector agent to FortiGate? (Choose two.)

22. Refer to the exhibit.

Assuming a default configuration, which three statements are true? (Choose three.)

23. Refer to the exhibit.

Which three pieces of information does the diagnose sys top command provide? (Choose three.)

24. Which statement about IKEv2 is true?

25. Exhibit.

Refer to the exhibit, which shows a partial output of diagnose hardware aysinfo memory.

Which two statements about the output are true? (Choose two.)

26. Refer to the exhibit, which shows the output of get router info bgp summary.

Which two statements are true? (Choose two.)

27. Exhibit.

Refer to the exhibit, which contains a screenshot of some phase 1 settings.

The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output.

Why?

28. Exhibit.

Refer to the exhibit, which shows a partial web fillet profile configuration.

Which action does FortiGate lake if a user attempts to access www. dropbox. com, which is categorized as File Sharing and Storage?

29. Which two statements about conserve mode are true? (Choose two.)

30. Refer to the exhibit, which shows the omitted output of a session table entry.

Which two statements are true? (Choose two.)

31. 1.Consider the scenario where the server name indication (SNI) does not match either the common name (CN) or any of the subject alternative names (SAN) in the server certificate.

Which action will FortiGate take when using the default settings for SSL certificate inspection?

32. Refer to the exhibit, which shows the output o! the BGP database.

Which two statements are correct? (Choose two.)

33. Which statement about protocol options is true?

34. Refer to the exhibit, which shows the output of get router info ospf neighbor.

What can you conclude from the command output?

35. Exhibit.

Refer to the exhibit, which shows two entries that were generated in the FSSO collector agent logs.

What three conclusions can you draw from these log entries? {Choose three.)

36. Which statement about parallel path processing is correct (PPP)?

37. Exhibit.

Refer to the exhibit, which contains partial output from an IKE real-time debug.

Which two statements about this debug output are correct? (Choose two.)

38. Refer to the exhibit, which shows partial outputs from two routing debug commands.

Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?

39. What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow? (Choose two.)

40. Exhibit.

Refer to the exhibit, which shows the output of a diagnose command.

What can you conclude about the debug output in this scenario?