Juniper JN0-650 Practice Exam Dumps (V8.02) for Your JNCIP-ENT Exam Preparation: Check the JN0-650 Free Dumps (Part 1, Q1-Q40) First

1. Which two statements are true regarding MDSP? (Choose two.)

2. Which three benefits does LLDP-MED provide in a voice environment? (Choose three.)

3. You have configured DHCP snooping on a Juniper switch.

Which statement is true?

4. Which two statements are true regarding MAC limiting on a Juniper switch? (Choose two.)

5. Which two statements are true regarding hierarchical queuing? (Choose two.)

6. You are securing the network using 802.1x access control. You apply 802.1x authentication on the distribution switch, as shown in the exhibit. You configure the switch port in single supplicant mode.

What will the result be?

7. Exhibit:

A router is attempting to form an OSPF neighborship with another router. However, the OSPF neighborship fails to establish completely.

Referring to the exhibit, what is the problem?

8. How does the Any-Source Multicast (ASM) model differ from the Source-Specific Multicast (SSM) model?

9. You have an MX960 configured as a Fusion aggregation device (AD) and two QFX5100 switches as satellite devices (SD). You have configured local- switching for each SD. A packet with an unknown MAC address is received on one of the SD extended ports.

Which statement is correct in this scenario?

10. Which statement is true regarding single-rate tricolor marking?

11. When configuring connectivity to a VoIP enabled phone, which two statements are correct? (Choose two.)

12. Click the Exhibit button.

Referring to the exhibit, which statement is correct when a failure exists on the link between host2 and switch5 on this EVPN-VXLAN fabric?

13. You enable the Multiple VLAN Registration Protocol (MVRP) to automate the creation and management of virtual LANs.

Which statement is correct in this scenario?

14. Your enterprise network is running BGP VPNs to support multitenancy. Some of the devices with which you peer BGP do not support the VPN NLRI. You must ensure that you do not send BGP VPN routes to the remote peer.

Which two configuration steps will satisfy this requirement? (Choose two.)

15. When configuring 802.1X authentication, what are three server fail fallback settings? (Choose three.)

16. You have a workstation and a VoIP phone connected to port ge-0/0/1 on an access switch.

Referring to the exhibit, which two statements are true? (Choose two.)

17. Your enterprise network uses routing instances to support multitenancy. Your Junos devices use BGP to peer to multiple BGP devices. You must ensure that load balancing is achieved within the routing instance.

Which two statements would accomplish this task? (Choose two.)

18. Click the Exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

19. Which variables directly influence an MDRR scheduler’s behavior in Junos OS? (Choose two)

20. You have deployed a Juniper switch that hosts multiple VLANs.

Which statement is true?

21. Which two statements are true regarding LLDP updates for device discovery? (Choose two.)

22. What is the correct authentication processing order on EX Series switches when multiple Layer 2 authentication methods are enabled?

23. You are configuring MVRP for automatic VLAN registration.

Which two statements are true? (Choose two.)

24. You notice a mass withdrawal of routes for some of the network hosts. You determine that the link on the ESI interface is down.

Which route type is used in this scenario?

25. Which statement is true regarding fixed classification in a Junos OS device?

26. Which two statements are true regarding auto-RP? (Choose two.)

27. What is the effect of the 'as-override' option in a BGP routing policy in Junos?

28. Which two statements are true regarding BGP load balancing? (Choose two.)

29. What is the main advantage of using Anycast RP over traditional RP in a multicast network?

30. Which Junos operational command is used to display the IS-IS adjacency table?

31. Exhibit:

Referring to the exhibit, which two statements are true regarding Q-in-Q tunneling? (Choose two.)

32. Which protocol is used to dynamically create and prune VLANs?

33. Which two statements are true regarding packet loss priority in CoS? (Choose two.)

34. User A in the exhibit has authenticated using 802.1X.

Which 802.1X supplicant mode must you configure on switch S1 to prevent User B and User C from also accessing the network? Click the Exhibit to see a larger version.

35. A router receives a BGP route from two IBGP peers. The routes are advertised with the same path attributes.

How does the router determine which peer should be installed as the forwarding next-hop?

36. You are deploying a EX Series switch to provide PoE support to telephones and security cameras using class mode power management. You want to ensure that the security cameras always have the necessary power to function.

How do you solve this problem?

37. Which two statements are true regarding BGP peering sessions? (Choose two.)

38. In Junos, which command would you use to troubleshoot issues with BGP prefix advertisement?

39. 1.You are configuring BGP within your network and are deploying route reflectors.

Which two statements are true? (Choose two.)

40. What is the primary function of the OSPF Area Border Router (ABR)?