JN0-281 Dumps (V9.02) Updated with the Latest & Verified Exam Questions and Answers – Pass Your Data Center, Associate (JNCIA-DC) Exam Successfully

1. Leaf and spine data centers are used to better accommodate which type of traffic?

2. When troubleshooting an OSPF neighborship, you notice that the router stopped at the ExStart state.

What is the cause of this result?

3. Which statement is correct about aggregate routes?

4. Which Junos OS routing table stores IPv6 addresses?

5. What is the primary purpose of an IRB Layer 3 interface?

6. Which two statements describe an IP fabric? (Choose two.)

7. Referring to the exhibit, why are the BGP routes hidden?

8. Which statement is correct about the BGP AS path when advertising routes?

9. Which statement is correct about a three-stage IP fabric underlay?

10. A routing policy has been created to advertise OSPF routes in BGP.

Which statement is correct in this scenario?

11. Which statement is correct about member interfaces when creating a LAG?

12. Which three actions are required to implement filter-based forwarding? (Choose three.)

13. Which signaling protocol is used for EVPN?

14. Which operation mode command will display the mapping between the VLAN ID and ports on a switch?

15. Within your router, you want to verify that you are learning routes from a remote BGP peer at IP address 10.10.100.1.

Which command would satisfy the requirement?

16. When a MAC limiting violation occurs, the switch performs which two actions by default? (Choose two.)

17. What information in the Ethernet header is used to populate the bridging table?

18. You are configuring an aggregate route. In this scenario, which two statements are correct? (Choose two.)

19. What are two requirements for an IP fabric? (Choose two.)

20. What is the main purpose of Bidirectional Forwarding Detection (BFD)?