Huawei H35-481_V2.0-ENU Exam Dumps (V9.02): Updated Study Materials for Your HCIP-5G-RAN V2.0 Exam Preparation

1. For ideal reliability in cooperative autonomous driving, which of the following needs to be met?

2. Which of the following descriptions regarding parameter configuration for NG-RAN to E-UTRAN handover is incorrect?

3. Which of the following is NOT an advantage of thin clients in CloudX's services?

4. Which of the following coding methods is primarily used in the 5G control channel?

5. What is the update cycle for Huawei's wireless base station RNA?

6. If the UE needs to initiate both intra-frequency and inter-frequency measurements, and the intra-frequency SMTC period is greater than or equal to the GAP measurement period, in situations where GAP is not supported. Which of the following situations will occur when a sharing mechanism is used?

7. Which of the following signaling messages can serve as evidence that the PSCI inter-site change preparation triggered by SgNB is successful?

8. In 5G Option 3X networking, at which layer of the end-user plane might multiple entities exist?

9. Which of the following is the primary requirement for 5G network performance from services such as smart buildings and smart streetlights?

10. Which aspect of the user plane will be cloud-based first?

11. Which of the following descriptions about the constraints of the PUCCH resource allocation protocol is incorrect?

12. If the reliability of a single connection is 99%, what is the reliability of a dual-connection primary/standby mode?

13. In an NR cell, which of the following indicators can reflect the coverage of UE service modes?

14. The person who proposes the requirement for network slicing is generally called, in which of the following ways?

15. When troubleshooting interference in an NR cell with SCS=30kHz, what is the normal interference noise floor at the PRB level?

16. When the subcarrier bandwidth is 60kHz, how many time slots are contained in each frame?

17. In a 5G cell, after the UE receives data packets from the PDSCH according to the DC information, which parameter is used to determine the downlink HARQ transmission time?

18. In vehicle-to-everything (V2X) technology, which of the following standards is more suitable for complex safety application scenarios?

19. In the SA network architecture, which layer does 5G RAN use to complete QoS mapping?

20. MU-MIMO is a very effective means of improving cell capacity. Different channels support different numbers of streams. Which of the following descriptions is incorrect?

21. Which of the following timers does not need to be sent to the UE and is only executed on the gNodeB side?

22. The UE measures the strength of three SSB beams in a single cell to be -70dBm, -74dBm, and -81dBm, respectively. The SSB merging threshold is -75dBm, and the merging count is 3. Which of these is the correct SSB measurement result for this cell?

23. In the terminal capability reporting, which of the following indicates that the terminal supports Tianxuan?

24. What parameter is used to characterize the bandwidth of a 5G cell system?

25. Which of the following power values is used as a reference for providing power to the other downlink channels in an NR cell?

26. What is the recommended downlink PDCP sequence number length for NR cells?

27. Which of the following descriptions about gNodeB QoS management is incorrect?

28. 3GPR15 defines the maximum bandwidth of 5G millimeter wave as which of the following?

29. What is the absolute value of the frame offset difference between PCe1 and SCe1 within the FR band for downlink CA requirements?

30. When the subcarrier spacing SCS in an NR cell is 30kHz, what is the maximum number of blind detections required by the PDCCH?

31. In the Opti3x architecture, during the establishment of a dual-connectivity connection, the eNB sends an ERABModityIND message to the MME. The IP address carried in this message belongs to which of the following network elements?

32. Which of the following descriptions about Massive MIMO antennas is incorrect?

33. In the case of a 100MHz bandwidth and 30kHz subcarrier in the C -band, how many downlink scheduling operations (DL) does the NR need to perform on the UE to achieve the peak data rate? How much does the grant need to be?

34. After what period of inactivity will a UE migrate from RRC CONNECTED to RRC INACTIVE state?

35. 1. Which of the following descriptions about pre-scheduling is incorrect?

36. Which of the following descriptions of key parameters for inter-frequency handover based on frequency priority is incorrect?

37. 5G has greatly promoted the development of smart healthcare. Which of the following application scenarios is considered the crown jewel of telemedicine?

38. Which of the following descriptions about the BWP handover mechanism is incorrect?

39. What are the horizontal and vertical 3dB beamwidths of the 64T64RAAU broadcast beam in the default configuration scenario?

40. What parameter distinguishes the B1 event measurement in NG-RAN from that in E-UTRAN?

41. In an SA cell, what does it mean if a terminal receives a TA value of 40?

42. Imbalanced receiving antennas in a terminal can affect RANK performance. Within what range can the average difference in RSRP between different antennas be considered balanced?

43. In a 5G RRC signaling configuration (cell-specific), if the static time slot is set to (5ms, 7.6.2.4) and SCS=30kHz, how many symbols does the GP (Guard Interval) occupy for this cell?

44. Which scenario is NOT included in the SgNB release triggered by SgNB?

45. Which of the following is a key capability of 5G network required for connected mobile nursing robots in smart healthcare?

46. Which of the following is an indicator of the NRDUCELL parameter of the measurement object?

47. Which gain of Massive MIMO cannot improve system coverage performance?

48. Which of the following alarms from Huawei base station equipment will NOT affect Massive MIMO performance?

49. 3GPPR15 protocol version primarily completes the specification for which of the following 5G scenarios?

50. What is the maximum number of symbols that can be configured in the PDSCH pre-DMRS?