HPE7-A01 Exam Dumps (V15.03) in Perspective: Pass Your Aruba Certified Campus Access Professional Exam Smoothly

1. A customer has a large number of food-producing machines

* All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120

* Several external technicians are maintaining this special equipment

What are the correct commands to ensure that no rogue DHCP server will impact the network?

A)

B)

C)

D)

2. Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

3. A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches cause network outages The switch should send a warning to the helpdesk when the problem occurs You have been asked to implement an effective solution to the problem.

What is the solution for this?

4. Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office You have configured a new group persona for the new branch office devices in Central, but you do not know their MAC addresses or serial numbers The office manager is instructed via text message on their smartphone to onboard all the new hardware into Aruba Central.

What application must the office manager use on their phone to complete this task?

5. Which statement best describes QoS?

6. You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?

7. You are helping an onsite network technician bring up an Aruba 9004 gateway with ZTP for a branch office The technician was to plug in any port for the ZTP process to start Thirty minutes after the gateway was plugged in new users started to complain they were no longer able to get to the internet. One user who reported the issue stated their IP address is 172.16 0.81 However, the branch office network is supposed to be on 10.231 81.0/24.

What should the technician do to alleviate the issue and get the ZTP process started correctly?

8. On AOS10 Gateways, which device persona is only available when configuring a Gateway-only group'?

9. Your manufacturing client is having installers deploy seventy headless scanners and fifty IP cameras in their warehouse These new devices do not support 802 1X authentication.

How can HPE Aruba reduce the IT administration overhead associated with this deployment while maintaining a secure environment using MPSK?

10. Refer to the exhibit.

A company has deployed 200 AP-635 access points. To but is not working as expected.

What would be the correct action to fix the issue?

11. Select the Aruba stacking technology matching each option (Options may be used more than once or not at all.)

12. What is the best practice for handling voice traffic with dynamic segmentation on AOS-CX switches?

13. You need to ensure that voice traffic sent through an ArubaOS-CX switch arrives with minimal latency What is the best scheduling technology to use for this task ? (Select two.)

14. How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

15. 1.Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device.

The following configuration was created on the switch:

A)

B)

C)

D)

16. Match the terms below to their characteristics (Options may be used more than once or not at all.)

17. What is an OSPF transit network?

18. You are configuring an SVI on an Aruba CX switch that needs to have the following characteristics:

* VLANID = 25

. IPv4 address 10 105 43 1 with mask 255 255 255.0

* IPv6 address fd00:5708::f02d:4df6 with a 64 bit prefix length

* member of VRF eng

* VRF eng and VLAN 25 have not yet been created

Which command lists will satisfy the requirements with the least number of commands?

A)

B)

C)

D)

19. You need lo have different routing-table requirements with Aruba CX 6300 VSF configuration Assuming the correct layer-2 VLAN already exists how would you create a new OSPF configuration for a separate routing table?

20. You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change.

What are two parts of the solution for these requirements? (Select two.)

A)

B)

C)

D)

E)

21. A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again.

Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device? (Select two.)

22. What steps are part of the Key Management workflow when a wireless device is roaming

from AP1 to AP2? (Select two.)

23. A customer is using Aruba Cloud Guest, but visitors keep complaining that the captive portal page keeps coming up after devices go to sleep Which solution should be enabled to deal with this issue?

24. With the Aruba CX switch configuration, what is the first-hop protocol feature that is used for VSX L3 gateway as per Aruba recommendation?

25. Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements After the configuration was complete, it was noted that a user assigned with the administrators role did not have the appropriate level of access on the switch.

The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role.

Which default management role should have been assigned for the user?

26. You are doing tests in your lab and with the following equipment specifications

* AP1 has a radio that generates a 10 dBm signal

* AP2 has a radio that generates a 11 dBm signal

* AP1 has an antenna with a gain of 9 dBi

* AP2 has an antenna with a gain of 12 dBi.

* The antenna cable for AP1 has a 2 dB loss

* The antenna cable for AP2 has a 3 dB loss

What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for APT?

27. A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus.

Which technology minimizes flooding so the legacy application can work efficiently?

28. A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the CX switch and the Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed messages on the Gateway to disrupt communications or obtain information about the network.

Which action must the administrator perform to address this situation?

29. In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations"? The wired host ingress traffic arrives on a trusted port.

30. Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

31. A network administrator is troubleshooting some issues guest users are having when connecting and authenticating to the network The access switches are AOS-CX switches.

What command should the administrator use to examine information on which role the guest user has been assigned?

32. Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)

33. What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2?

34. A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office An untrained local field technician will do the rollout of the switches and the mounting of several AP-515s and AP-575S. Cables running to theAPs are not labeled.

The VLANs are already preconfigured to VLAN 100 (mgmt), VLAN 200 (clients), and VLAN 300 (guests).

What is the correct configuration to ensure that APs will work properly?

A)

B)

C)

35. In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

36. You are deploying a bonded 40 MHz wide channel.

What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

37. A network administrator is attempting to troubleshoot a connectivity issue between a group of users and a particular server The administrator needs to examine the packets over a period of time from their desktop; however, the administrator is not directly connected to the AOS-CX switch involved with the traffic flow.

What statements are correct regarding the ERSPAN session that needs to be established on an AOS-CX switch'? (Select two )

38. Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

39. Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)

40. A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subcamers to clients.

Which technology is the best match for this use case?

41. You are setting up a customer's 15 headless loT devices that do not support 802.1X..

What should you use?

42. What is a primary benefit of BSS coloring?

43. Match the solution components of NetConductor (Options may be used more than once or not at all.)

44. List the WPA 4-Way Handshake functions in the correct order.

45. Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

46. What is true regarding 802.11k?

47. A customer wants to enable wired authentication across all their CX switches One of the requirements is that the switch must be able to authenticate a single computer connected through a VoIP phone.

Which feature should be enabled to support this requirement?

48. Review the exhibit.

You are troubleshooting an issue with a 10 102.39 0/24 subnet which is also VLAN 1000 used Tor wireless clients on a pair of Aruba CX 8360 switches The subnet SVI is configured on the 8360 pair, and the DHCP server is a Microsoft Windows Server 2022 Standard with an IP address of 10 200 1.100. The 10.102.250.0/24 subnet is used for switch management.

A large number of DHCP requests are failing You are observing sporadic DHCP behavior across clients

attached to the CX 6100 switch.

Which action may help fix the issue?

A)

B)

C)

D)

49. Two AOS-CX switches are configured with VSX at the the Access-Aggregation layer where servers attach to them An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been configured on the VSX switches.

What is correct about access from the servers to the Core? (Select two.)

50. Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

51. What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?

52. The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to the AOS-CX switch.

An administrator has performed the following configuration

What is the most likely cause of this issue?

53. A company recently deployed new Aruba Access Points at different branch offices Wireless 802.1X authentication will be against a RADIUS server in the cloud. The security team is concerned that the traffic between the AP and the RADIUS server will be exposed..

What is the appropriate solution for this scenario?

54. When setting up an Aruba CX VSX pair, which information does the Inter-Switch Link Protocol configuration use in the configuration created?

55. The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches.

What is the benefit of VSX clustering with the new solution?