DumpsBase Fortinet NSE7_SDW-7.0 Dumps (V10.02) – Guarantee of Success in Fortinet NSE 7 – SD-WAN 7.0 Certification Exam

1. Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

2. Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two.)

3. Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)

4. Refer to the exhibits.

Exhibit A

Exhibit B -

Exhibit A shows the configuration for an SD-WAN rule and exhibit B shows the respective rule status, the routing table, and the member status.

The administrator wants to understand the expected behavior for traffic matching the SD-WAN rule. Based on the exhibits, what can the administrator expect for traffic matching the SD-WAN rule?

5. Refer to the exhibits.

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.

Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)

6. Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)

7. Refer to the exhibits.

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)

8. Refer to the exhibit.

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?

9. Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?

10. Refer to the exhibits.

Exhibit B

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.

Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?

11. Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

12. Refer to the exhibit.

An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.

Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)

13. Refer to the exhibit.

Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose two.)

14. Which two statements about SD-WAN central management are true? (Choose two.)

15. Refer to the exhibits.

Which conclusion about the packet debug flow output is correct?

16. Which are two benefits of using CLI templates in FortiManager? (Choose two.)

17. What is the route-tag setting in an SD-WAN rule used for?

18. Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.

Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?

19. Refer to the exhibits.

Exhibit A -

Exhibit B -

Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.

The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.

Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?

20. Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.

What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?