(December 2023) Newly Updated JN0-363 Dumps to V10.03 as Your Best Preparation Materials for Learning

1. Which BGP attribute Is used to detect touting loops?

2. What is the correct order of BGP attributes for active route selection?

3. Which new field is added to an IPv6 header as compared lo IPv4?

4. How does a Junos device learn about MAC addresses when II is first connected to an Ethernet LAN?

5. Which LSA type does an OSPF ABR use to advertise external routes generated by an NSSAASBR into the backbone?

6. Exhibit

You have configured graceful RE switchover (GRES), however you cannot complete the show system switchover command.

Referring to the exhibit, what is the problem?

7. Which statement is correct about IS-IS?

8. Exhibit

Which prefix in the output shown in the exhibit is an external prefix injected by an OSPF router?

9. Interface ge-0/0/0.0 connecls yout network to your ISP. You want to advertise this interface address as an Internal route In OSPF without creating a neighbor with your ISP.

In this scenario, how is this task accomplished?

10. 20.1.0/24

Referring to the exhibit, which two statements are correct? (Choose two.)

11. What are three well-known mandatory BGP attributes? (Choose three.)

12. Which two statements are correct about IS-IS? (Choose two.)

13. What are two types of SlDs used in segment touting? (Choose two.)

14. Exhibit

The LSP is not establishing correctly.

Referring to the exhibit, what should you do to solve the problem?

15. Exhibit

Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit? (Choose two.)

16. Which two statements ate correct about the community BGP attribute on a Junos device? (Choose two.)

17. You want to see a detailed list of all established BGP sessions.

In this scenario, what would be a valid command to accomplish this task?

18. Exhibit

Referring to the exhibit, internal BGP between R1 and R2 is not establishing.

What is the problem In this scenario?

19. Exhibit

Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)

20. Exhibit

Referring to the exhibit, where should next-hop-self-policy be applied to alter the next-hop value?

21. Which statement describes integrated routing and bridging (IRB) interfaces?

22. Exhibit

The routers shown in the exhibit ate configured for segment routing.

In this scenario, what is the adjacency SIO that Router B advertises to Router A?

23. You have created a routing instance named vr3 that will provide access to Server 2 (10.0.0.2) (or the hosts on the 10.10.10.0/24 network.

Which command would you use to test connectivity between vr3 and Server 2?

24. Which configuration selling prohibits a static route from being redistributed by a dynamic routing protocol?

25. Exhibit

Referring to the exhibit, which two statements are correct? (Choose two.)

26. You are asked to create connections between routing instances on the same Junos device and route between the connected Instances.

What are two ways to accomplish this task? (Choose two.)

27. Exhibit.

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24, 172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route hidden.

Which action would you perform to determine the problem?

28. You are adding an IPv6 configuration to an Interface on a Junos device.

In this scenario, which statement is correct?

29. Exhibit

Referring to the exhibit, which statement is true about VRRP?

30. Exhibit

Referring to the exhibit, how do you verify the status of the tunnel from R1?