Juniper JN0-281 Dumps (V10.02) for Data Center, Associate (JNCIA-DC) Certification Preparation – Achieve Success for 2026 Career

1. A switch receives an Ethernet frame that contains source and destination MAC addresses that are not in the Ethernet switching table.

In this scenario, which two actions does the switch perform? Choose two.

2. You are asked to ensure that traffic and routing information is not interrupted if your primary Routing Engine fails or switches to the backup Routing Engine.

In this scenario, which high availability feature will accomplish this behavior?

3. What are two BGP message types? Choose two.

4. You have a problem bringing up an aggregated Ethernet interface between a spine and a leaf.

Referring to the exhibit, what is the problem?

5. Referring to the exhibit,

what is indicated by the OpenConfirm state?

6. Which two statements are correct about configuring VLANs? Choose two.

7. What is the purpose of generated routes? Choose one.

8. Which statement is correct about the native VLAN ID feature? Choose one.

9. Which statement is correct about access ports?

10. What are two ways to solve the configuration error shown in the exhibit? Choose two.

11. Which statement is correct about building an IP fabric?

12. Which statement is correct about building an IP fabric?

13. Which statement is correct about nonstop bridging? Choose one.

14. Which high availability feature permits you to combine multiple Ethernet interfaces into a single link layer interface?

15. Referring to the exhibit,

how much time must pass before a neighbor is considered down?

16. Which two statements about EBGP are correct? Choose two.

17. Which feature should be used with a static route that has a secondary next hop with a unique route preference value? Choose one.

18. Which two statements about overlay networks are correct? Choose two.

19. What is a function of an integrated routing and bridging IRB interface?

20. Which protocol is supported in an IP fabric underlay network? Choose one.