FREE Juniper JN0-102 JNCIA-Junos Dumps

1. Which two commands would you use to discard a candidate configuration? (Choose two.)

2. Which two statements are true about the configure exclusive command? (Choose two.)

3. Which command will display the active configuration?

4. Which three commands will cause a logical interface to go administratively down after being committed? (Choose three.)

5. Which command returns a list of commands in which a given keyword is used throughout the Junos hierarchies?

6. Which three statements are true regarding the candidate configuration? (Choose three.)

7. -- Exhibit --
[edit]
user@router# show | compare
[edit protocols ospf area 0.0.0.0]
- interface ge-0/0/0.0 {
- disable;
- }
[edit protocols ospf]
area 0.0.0.0 { ... }
+ area 0.0.0.1 {
+ interface ge-0/0/0.0;
+ }
-- Exhibit --
Referring to the exhibit, what are two differences between the active and candidate configurations? (Choose two.)

8. Which mode is used to allow only a single person to edit a configuration?

9. Which information would you find using the CLI help function? (Choose two.)

10. Which two statements are true of login classes? (Choose two.)

11. Which two statements are true regarding rescue configurations? (Choose two.)

12. -- Exhibit --
Amnesiac (ttyu0)
login:
-- Exhibit --
Which statement is correct about the information shown in the exhibit?

13. Which two statements are true regarding the use of NTP clock synchronization? (Choose two.)

14. You are asked to change the cable on interface ge-2/1/3.
Which statement is correct?

15. You are asked to change the cable on interface fe-4/2/3.
Which statement is correct?

16. You are asked to change the cable on interface ge-0/2/1.
Which statement is correct?

17. -- Exhibit --
user@router> show configuration
groups {
ge-int {
interfaces {
<ge-*> {
unit 0 {
familyinet {
address 10.10.12.1/24;
}
}
}
}
}
}
...
interfaces {
ge-0/0/1 {
unit 0;
}
-- Exhibit --
Referring to the exhibit, which two actions would you take to only apply the 10.10.12.1/24 address to the ge-0/0/1.0 interface?

18. Which interface type connects the control and forwarding planes on an MX Series device?

19. Which command is used to restore a Junos device to its default state?

20. -- Exhibit --
{master:0}[edit interfaces]
user@switch# show
me0 {
disable;
unit 0 {
familyinet {
address 10.1.1.10/24;
}
}
}
-- Exhibit --
Administrators report that they are unable to access the management interface of the EX Series device shown in the exhibit.
Which command will resolve this problem?