CQE Dumps (V9.02) with CQE Free Dumps (Part 2, Q41-Q70): Pass Your Certified Quality Engineer (CQE) Exam By Learning the Latest Q&As

1. When subgroups are selected in a way that minimizes the opportunity for variation within a subgroup and maximizes the opportunity to detect variation between subgroups, this subgrouping is known as

2. A test-retest study is performed to a coordinate measuring machine (CMM) using a working standard of 100.00 ± 0.001 mm (95% confidence). The length of the standard is measured 30 rimes. The mean and standard deviation of the measurements are x = 107.883 mm and 5 = 2.497 mm. All of the measurements are made are the same location on the standard and are taken by the same technician, who mounts and dismounts the unit for each measurement.

The precision of the CMM is estimated to be

3. How many total degrees of freedom are in an unreplicated 23 factorial experiment?

4. Which of the following symbols indicates a termination point on a flowchart?

5. What is the appropriate number of class intervals for the construction of a histogram generated from 36 observations?

6. Which of the following statements is always true about an effective design review?

7. A system to capture product revisions that must be tracked is more commonly known as

8. If the mean time between failures (MTBF) for a device is 200 hours, what is the constant failure rate per hour?

9. Quality planning is an activity that identifies the needs of which of the following stakeholders?

10. The best reason to record and distribute meeting minutes is to

11. The starting point for an organization when conducting a risk-based audit is to

12. Which of the following statements best describes precision?

13. A process has the following output characteristics:

Mean = 28.65

Median = 24

Mode = 20

The uniniodal distribution with these characteristics is defined as

14. The following drawing is for a machined part.

What does the symbol represent?

15. M in tills drawing, the symbol is being used to indicate the H Calculator

16. If a value assigned to a unit is non-numerical. it is described as

17. The following chart is being used to monitor a process.

What do points X and Y. and region Z represent on the chart?

18. Which of the following definitions describes severity?

19. Based on the FMEA results below, which of the following items should be prioritized first?

20. Which of the following activities is a form of error-proofing?

21. Which of the following tools can be used to show a frequency distribution?

22. Which of the following is the most important aspect of a successful quality improvement effort?

23. Which of the following tools should be used to break a broad goal into increasingly detailed levels?

24. A process produces rejects at a rate of 6° o. If multiple samples of 5 are drawn from a population of 100.000. what is the expected number of rejects per sample?

25. Which of the following factors has the most influence on the success of quality initiatives?

26. Which of the following tools can be used to classify or determine a safety quality characteristic?

27. A process that is in control has the following characteristics. If the specification is 100 ± 3.

What portion of the product is expected to meet specification?

X=101

R =4

n = 5

H Calculator

28. A process capability analysis can best be used to

29. The authority for a customer to perform audits at a supplier's facility can usually be found in the customer's

30. Adjusting machine settings to reduce the effect of ambient temperature changes on the seal strength of a paper package is an example of