Real H35-581_V2.0-ENU Exam Dumps (2024 Release) – Pass HCIP-5G-RNP&RNO V2.0 Certification Exam Successfully

1. How many bits are the uplink power control commands in 5G?

2. Regarding 5G DRX parameter configuration, which description is wrong?

3. In the NSA networking scenario, which of the following neighbor cells does not require planning?

4. In Huawei base stations, what is the minimum aggregation level of PDCCH CCE?

5. In the ANR process, which system information of the neighboring cell does the UE need to read?

6. In CA, SCELL changes are triggered by which of the following events?

7. In high-frequency scenarios , how many carriers of CA can Huawei equipment currently support ?

8. Which event reporting is used to trigger CA Scell addition process?

9. Which of the following KPI indicators cannot be counted based on the community?

10. In Huawei gNB, which protocol layer is the traffic statistics indicator based on?

11. If SCG addition based on traffic volume is enabled, which protocol layer's service measurement is used to trigger by eNodeB?

12. After NSA high load protection is turned on, which of the following option descriptions is correct?

13. In the PDCCH CCE aggregation level adjustment algorithm, which of the following parameters does gNB use as input?

14. Which of the following NSA frequency band combinations may have second-order intermodulation interference?

15. For 64TRX AAU , what is the maximum vertical scanning angle supported by SSB?

16. In Huawei base stations, when long format PUCCH is used, what is the fixed number of symbols?

17. Which of the following is the first step in the downlink beamforming process?

18. In the PUSCH power algorithm, the path loss is calculated through the measurement of which channel?

19. If SRS does not support independent power control, then the power control command of SRS is the same as which of the following channels?

20. What kind of measurement index is used in the outer loop power control of PUCCH?

21. How many logical channel groups can be defined in total for 5G uplink?

22. Which of the following types of services has the highest scheduling priority?

23. In the inter-frequency switching scenario based on frequency priority, which of the following event measurement reports is used to trigger inter-frequency measurement?

24. During the handover preparation process, the source cell determines the target cell for handover based on which of the following parameters?

25. Which of the following messages does the LTE network deliver the reselection parameters of the NR frequency point?

26. In the 5G inter-frequency reselection process, through which message does the terminal obtain the reselection priority?

27. Regarding the reselection from 4G to 5G, which of the following descriptions is correct?

28. Which of the following RNTIs is not used for scrambling PDCCH?

29. How many CQI mapping tables are defined in NR?

30. Which of the following is not the possible bandwidth of CORESETO?

31. Which of the following is not a function of the RLC layer in NR?

32. Which of the following formats PUCCH does not have DMRS?

33. How many formats of PUCCH channel?

34. Which of the following is a physical layer processing step unique to the DTF-S-OFDM waveform?

35. Which of the following parameters determines the channel time domain position of PRACH?

36. In the Rell5 version, what is the maximum number of code words for PUSCH?

37. Regarding the description of PDSCH and PUSCH, which of the following descriptions is wrong?

38. What is the maximum number of PRBs contained in 1 RBG?

39. For the public PDCCH space, what is the minimum CCE format?

40. Regarding SSB measurement, which of the following descriptions is correct?

41. Regarding the switching mechanism of BWP, which of the following descriptions is wrong?

42. Which of the following reference signal positions is related to PCI?

43. In 100MHz, 30KHz, SCS network, what is the maximum bandwidth of SRS?

44. When 4 downlink streams are used, which of the following configuration schemes for PDSCH DMRS has the highest overhead?

45. Regarding the description of the SSB physical cycle, which of the following descriptions is wrong?

46. For the N78 frequency band, which of the following time slot ratios (downlink: uplink) can support the transmission of 8 SSB beams?

47. Which of the following BWPs is at the community level?

48. Regarding the SgNB release process under EN-DC, which of the following statements is wrong?

49. Under the Opiton3x architecture, if the SgNB addition process is triggered, a maximum of how many tunnels will be established on the X2-U interface?

50. In the RRC Inactive state, what is the scope of the UE paging message?

51. Under the Option3x architecture, during the dual connection establishment process, the eNB will send an ERAB Modify IND message to the MME. Which network element does the IP address carried in the message belong to?

52. In a low-frequency scenario, how does the UE obtain the beam ID of the current SSB?

53. Regarding UE access on the 5G side in the NSA scenario, which of the following descriptions is wrong?

54. Under NSA networking, the MR reported by the UE based on which event will trigger the SgNB release process?

55. Which of the following NAS messages will carry QFI parameters?

56. What are the possible number of RBs for Preamble in the frequency domain?

57. In NSA networking, if the 5G SSB frequency configured on the eNodeB side is inconsistent with the actual one, which of the following problems will occur?

58. Which protocol layer is the rate measured when filling packets on the 5G air interface?

59. If the sequential delivery mechanism is adopted, which layer of protocol implements the reordering of the 5G air interface?

60. If the terminal only supports the tig natural selection function, assuming that the SRS SINR is greater than the threshold of the SRS weight and the RANK reported by the UE is 3, then what method will the gNB use to calculate the beamforming weight?

61. What is the maximum number of PDCCH blind detections by the UE in a time slot?

62. Which of the following content cannot be transmitted by PDCCH?

63. Which parameter in the MIB message indicates the time domain position of CORESETO?

64. Regarding the description of the RNA region, which of the following descriptions is incorrect?

65. In high-frequency scenarios, how does the UE obtain the beam ID of the current SSB?

66. In the SIB1 message, if the expected preamble power is -100dBm, the SSB transmit power is 18dBm, and the current RSRP is -90dBm, then what is the transmit power of the terminal's first PRACH preamble?

67. In Huawei base stations, what is the maximum number of streams for PDCCHMU-MIMO spatial division multiplexing?

68. In Huawei base stations, which of the following SRS resources are only used for high-frequency networking?

69. In intra-frequency handover, which can achieve handover to a specific neighboring cell easier?

70. gNB triggers the blind redirection process based on the reporting of which of the following events?

71. Which of the following parameters will not appear in the SCG configuration message?

72. During the NSA access process, if the terminal fails to randomly access the NR side, what process will the terminal initiate afterwards?

73. During the drive test, if the downlink MCS is low, is it related to the quality of which of the following channels?

74. Regarding the description of 5G wireless cell power design, which of the following is incorrect?

75. In PLMN selection, which of the following PLMNs has the highest priority?

76. In general scenarios, what is a reasonable IBLER target value setting for PDSCH?

77. Compared with LTE, which layer of NR has new sorting and copying functions?

78. Which of the following COREST is used for RMSI scheduling?

79. If SCG Split Bearer is used, which of the following will be used to split user plane data?

80. Regarding the impact of uplink and downlink decoupling on LTE, which of the following descriptions is incorrect?

81. PUCCH format 0 and format 1 can only transmit less than how many bits of data, so they are mainly used for CSI reporting?

82. Regarding PDCCH resources, which of the following descriptions is incorrect?

83. Which of the following parameters is used to indicate the best CSI-RS beam?

84. Which of the following parameters indicates the bit rate that the network guarantees to provide to QoS Flow within the average time window?

85. Which of the following modulation methods are used in the PUCCH and PDCCH channels in NR?

86. Which of the following bearers is used in NSA dual connectivity scenario?

87. Regarding the advantages of ray tracing models, which of the following statements is incorrect?

88. Which of the following is the adjustment granularity of the 5GAAU adjustable electrical downtilt angle?

89. Regarding the description of 5G neighborhood planning, which of the following is incorrect?

90. SCel deletion is based on which of the following measurement events?

91. Assuming that the current SINR is 30dB and the CSI-RS RSRP is -70dBm, which of the following aggregation levels is recommended for CCE?

92. If two or more cells with the same frequency and same PCI are geographically adjacent to each other, the signals in the overlapping area between the cells will interfere with each other, and the UE cannot correctly demodulate the signal in the overlapping area, resulting in an increase in the call drop rate on the existing network. High, the PCI conflict in this case is called which of the following?

93. For cross-operator boundary scenarios, if such neighboring cells are not added to the NCL and NRT tables, the UE will repeatedly read the CGI and may result in selecting the wrong handover target cell. Therefore, it is recommended that such different operator PLMNs be Which of the following PLMN lists should be set to?

94. In NSA networking, in order to support the neighbor cell self-configuration function in the NR system or the LTE automatic configuration NR neighbor cell function, which of the following system messages does the NR cell need to send?

95. If the SCell co-channel neighbor cell level value is higher than SCell by a certain threshold , which of the following events will be triggered?

96. Which of the following technologies has the disadvantage of relatively high peak average power and the advantages of flexible resource allocation and large frequency diversity gain?

97. If the reason value carried in the SgNB_Add_Reject message is Transport resource not available, which of the following may be the cause of the problem?

98. What is the maximum level that the downlink 64QAM MCS can reach?

99. Which of the following values must be exceeded by the UE camping in the current serving cell to trigger cell reselection to a high-priority cell?

100. When the source gNodeB receives which of the following signalings from the target gNodeB? N.HO.IntraFreq.Xn.lntergNB.ExecSuccOut will be increased by 1 time.