Fortinet NSE 5 – FortiAnalyzer 6.2 NSE5_FAZ-6.2 Dumps Questions V9.02 Updated

1. By default, what happens when a log file reaches its maximum file size?

2. Which statements are correct regarding FortiAnalyzer reports? (Choose two)

3. Refer to the exhibit.

What does the data point at 14:55 tell you?

4. On FortiAnalyzer, what is a wildcard administrator account?

5. How does FortiAnalyzer retrieve specific log data from the database?

6. For which two purposes would you use the command set log checksum? (Choose two.)

7. FortiAnalyzer uses the Optimized Fabric Transfer Protocok (OFTP) over SSL for what purpose?

8. What remote authentication servers can you configure to validate your FortiAnalyzer administrator logons? (Choose three)

9. What is the purpose of employing RAID with FortiAnalyzer?

10. Logs are being deleted from one of the ADOMs earlier than the configured setting for archiving in the data policy.

What is the most likely problem?

11. View the exhibit:

What does the 1000MB maximum for disk utilization refer to?

12. When you perform a system backup, what does the backup configuration contain? (Choose two.)

13. Which two of the following must you configure on FortiAnalyzer to email a FortiAnalyzer report externally? (Choose two.)

14. You are using RAID with a FortiAnalyzer that supports software RAID, and one of the hard disks on FortiAnalyzer has failed.

What is the recommended method to replace the disk?

15. What statements are true regarding disk log quota? (Choose two)

16. What purposes does the auto-cache setting on reports serve? (Choose two.)

17. Which two statements about log forwarding are true? (Choose two.)

18. Which statements are true of Administrative Domains (ADOMs) in FortiAnalyzer? (Choose two.)

19. What are the operating modes of FortiAnalyzer? (Choose two)

20. View the exhibit.

What does the data point at 14:35 tell you?