HCIA-5G-RAN V3.0 H35-480_V3.0-ENU Real Dumps Questions Online

1. Which of the following methods can be used to obtain VLAN IDs after a base station is powered on?

2. After the NR base station commissioning is complete and before services go online, which of the following must be set for the NE status?

3. The purpose of replaying logfiles is to reproduce the test process. The GENEX Probe can work without license in this case.

4. What is the maximum MIMO mode supported by Huawei 5G indoor CPE?

5. What are the typical sizes of ping packets and intervals in single site verification?

6. In NSA networking, which of the following modes is used to anchor 5G NR?

7. Which of the following statements about the NR slot structure are correct?

8. The BBU5900 uses a modular design.

Which of the following subsystems constitute the BBU?

9. 5G wireless network cloudification can significantly improve the user rate.

10. Which of the following statements about the functions of an AAU are correct?

11. C-band is the most popular frequency band for 5G network deployment. However, there is an imbalance between uplink and downlink coverage ― how much does this imbalance approximately amount to?

12. gNodeBs periodically send TPC commands to UEs over PDCCHs to control the transmit power of which of the following uplink channels or signals of UEs?

13. The RSRP value of the test terminal can be viewed on the GENEX Probe.

Which of the following test results indicate good signal quality?

14. On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

15. In what scenarios is GENEX Assistant typically applied?

16. Which of the following files must be prepared when remotely commissioning a gNodeB using the MAE Deployment?

17. An NR CQI value represents a coding scheme and coding efficiency.

How many bits does a CQI value reported by a UE have?

18. In the inter-site DC solution, the X2 interface can be used to implement transmission interconnection between the LTE and NR sites.

Which of the following is the requirement of the transmission delay in such case?

19. Which of the following factors trigger measurement in connected mode in SA networking?

20. SSB GSCN is the center frequency number of an NR cell.