Check NSE6_SDW_AD-7.6 Free Dumps (Part 2, Q41-Q70) of V8.02 Today – Verify DumpsBase NSE6_SDW_AD-7.6 Dumps for Certification Success

1. What is the purpose of using dynamic routing protocols in a hub-and-spoke IPsec topology for SD-WAN and ADVPN?

2. What are two common use cases for remote internet access (RIA)? (Choose two.)

3. Which are three key routing principles in SD-WAN? (Choose three.)

4. Which two interfaces can be added to SD-WAN as members? (Choose two.)

5. You are configuring SD-WAN zones and members on a FortiGate device.

Which two facts should you take into account? (Choose two.)

6. Which three matching traffic criteria are available in SD-WAN rules? (Choose three.)

7. Refer to the exhibits.

Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.

Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?

8. What is the purpose of configuring SD-WAN Members and Performance SLAs?

9. In a hub-and-spoke SD-WAN topology, you choose OaaS for your overlays.

What type of routing can you use on the branches?

10. Which feature of FortiManager allows for the creation of custom templates for SD-WAN devices?

11. Which are two benefits of using CLI templates in FortiManager? (Choose two.)

12. Refer to the exhibit.

How does FortiGate handle the traffic with the source IP address 10.0.1.27 and the destination IP address 128.66.0.111?

13. 1.Which SD-WAN traffic shaping technique prioritizes critical applications and limits bandwidth for non-critical applications?

14. Refer to the exhibits.

The VPN configuration on a spoke and a hub is shown.

The administrator wants to use those tunnels to build an SD-WAN topology.

Which one parameter must you modify to allow the tunnel to come up and be used in the SD-WAN topology?

15. Which SD-WAN deployment type is most suitable for a hub-and-spoke IPsec topology with ADVPN?

16. What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)

17. Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two.)

18. Refer to the exhibit.

The exhibit shows the SD-WAN rule status and configuration.

Based on the exhibit, which change in the measured packet loss will make T_INET_1_0 the new preferred member?

19. Refer to the exhibit.

An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.

Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)

20. Refer to the exhibits.

An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in exhibit A.

After generating GoToMeeting test traffic, the administrator examined the respective traffic log on FortiAnalyzer, which is shown in exhibit B. The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.

Which two reasons explain why the traffic matched the implicit SD-WAN rule? (Choose two.)

21. Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?

22. An administrator configured a best quality SD-WAN rule with WAN1 and WAN2 as members. WAN1 has the highest configuration priority, and link-cost-threshold is set to 10. FortiGate reports a latency of 100 ms and 120 ms for WAN1 and WAN2, respectively.

Which change in the measured latency will make WAN2 the new preferred member?

23. Which component in a hub-and-spoke IPsec topology serves as the VPN gateway for spoke sites?

24. Why is it effective to use SD WAN rules when configuring application control?

25. Which component in a hub-and-spoke IPsec topology serves as the central point of management and configuration?

26. What is the purpose of using FortiManager with FortiDeploy for SD-WAN management?

27. Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

28. Which three protocols can be used for the status check in a performance SLA? (Choose three.)

29. Refer to the exhibit.

Which are two expected behaviors of the traffic that matches the traffic shaper? (Choose two.)

30. Which two statements correctly describe what happens when traffic matches the implicit SD-WAN rule? (Choose two.)