Test FREE Dell EMC E20-375 Real Exam Questions

1. A company with a DR site connected with a 2 Gbps FC link has three vRPAs at each site. They are experiencing High Load events, although the FC link is not fully utilized.
What would be the best solution to get the FC link utilization up as high as possible while mitigating those events?

2. What should be used when more performance is needed than a single RPA can provide for asynchronous replication?

3. You are protecting a volume using the wizard in Unisphere for RecoverPoint.
Which state will the new Consistency Group be in immediately after completing the wizard?

4. Which FA ports must the production LUN be mapped to in order to perform write splitting using the VMAX splitter?

5. A Consistency Group consists of one production copy, one local copy, and two remote copies.
How many journals are required for this configuration?

6. You are creating a Consistency Group with the Protect Volumes wizard in a RecoverPoint/EX environment.
What LUNs are displayed in the list generated by the wizard?

7. What is a named point-in-time copy of data marked by the system for recovery purposes within RecoverPoint?

8. What is the first operation involved in the RecoverPoint Initialization process?

9. What is a characteristic of a full sweep?

10. What is a characteristic of a volume sweep?

11. How much data, at a minimum, must change in order for the snapshot consolidation process to start?

12. What user action causes a full sweep to occur?

13. Which statement is true about Logged Access mode?

14. When a copy is in Image Access mode, where is the Image Access Log stored?

15. You are a storage administrator tasked with creating a Consistency Group in a RecoverPoint/EX system. You launch the Protect Volumes wizard in Unisphere and notice that the desired production volume is not available.
What would be a possible cause?

16. You are a storage administrator tasked with creating a Consistency Group in a RecoverPoint/EX system. You launch the Protect Volumes wizard in Unisphere and notice that the desired production volume is not available.
What would be a possible cause?

17. Which Image Access Mode should be used when large portions of an image might be changed?

18. If you wanted to use the Roll Image in Background option to access an image, which access mode should you select?

19. Which image access mode provides the quickest way to access data?

20. When determining the journal volume size, which parameters must be considered?