Pass 350-601 DCCOR Exam With The Valid Dumps

350-601 Implementing and Operating Cisco Data Center Core Technologies (DCCOR) is associated with three Cisco certifications:

  • CCNP Data Center
  • CCIE Data Center
  • Cisco Certified Specialist – Data Center Core

You can pass 350-601 DCCOR exam with the most valid dumps. We have released new 350-601 exam dumps with real exam questions and accurate answers on April 7, 2020. We can be sure that you can pass your 350-601 Implementing and Operating Cisco Data Center Core Technologies (DCCOR) exam in the first time the valid 350-601 DCCOR dumps.

You can come to check DumpsBase 350-601 DCCOR free dumps.

1. DRAG DROP

An engineer is implementing NetFlow on a Cisco Nexus 7000 Series Switch.

Drag and drop the NetFlow commands from the left into the correct order they must be entered on the right.

2. Which virtual MAC address is the default for HSRP version 2 group 10?

3. Refer to the exhibit.

Which statement about the ERSPAN configuration in this environment is true?

4. Refer to the exhibit.

Which two statements about the routing table of the leaf switch are true? (Choose two.)

5. Which mroute state is created when Bidirectional PIM is deployed at a site?

6. Refer to the exhibit.

Which statement about the default gateway configuration of the vPC is true?

7. Refer to the exhibit.

What must be connected to clear the HA NOT READY status?

8. A small remote office is set to connect to the regional hub site via NSSA ASBR.

Which type of LSA is sent to the remote office OSPF area?

9. Which adjacency server configuration makes two OTV edge devices located in the same site bring up the dual-site adjacency?

A)

B)

C)

D)

10. Refer to the exhibit.

The STP priority of N7K-1 and N7K-2 are the lowest in the network.

Which statement describes STP on the vPC?

11. The engineer must configure SPAN on a Cisco Nexus 5000 Series Switch to get a capture of the traffic from these applications for an in-depth packet analysis.

Which two SPAN characteristics must be considered? (Choose two.)

12. Host1 is in VLAN100 located in DataCenter1 and Host2 is in VLAN200 located in DataCenter2.

Which OTV VLAN mapping configuration allows Layer 2 connectivity between these two hosts?

A)

B)

C)

D)

13. Refer to the exhibit.

What is configured as a result of running these commands?

14. Which configuration implements static ingress replication?

A)

B)

C)

D)

15. Refer to the exhibit.

A network engineer is setting up a multihomed OTV network. The first site has been set up with a primary and secondary adjacency server.

Which configuration must be added on the remote OTV AEDs site?

A)

B)

C)

D)

16. A customer has a requirement to deploy a cloud service and needs to have full control over the underlying OS, data and applications.

Which cloud model meets this requirement?

17. Refer to the exhibit.

A flapping link issue has been reported on the vPC keepalive link. A packet capture has been activated on the Cisco Nexus switch.

What is the destination IP address of the vPC keepalive packets that are sent by the switch?

18. Due to a major version change, an engineer must perform a software upgrade on a Cisco Nexus Series switch.

Which two technologies can be implemented to reduce disruptions to the network during the upgrade? (Choose two.)

19. Refer to the exhibit.

Which result of running the command is true?

20. Refer to the exhibit.

What is the reason the system-fm-vrrp checkpoint was created?

21. What are two capabilities of the Cisco Network Assurance Engine? (Choose two.)

22. What is an advantage of streaming telemetry over SNMP?

23. APIC EPG Resolution Immediacy is set to "Immediate".

Which statement is true about the Deployment Immediacy for VMM domains associated to EPGs?

24. Which method must a network engineer use to upgrade the BIOS firmware or a Cisco UCS standalone C-Series rack-mount server?

25. Which action must be performed before renumbering a Cisco UCS chassis?

26. A server engineer wants to control power usage on a Cisco UCS C-Series rack server down to the component level.

Which two components support specific power limits? (Choose two.)

27. An engineer is implementing an import operation in Cisco UCS Manager.

What is the impact of performing this operation?

28. An engineer wants to create a backup of Cisco UCS Manager for disaster recovery purposes.

What are two characteristics of a full state backup of a Cisco UCS Manager database? (Choose two.)

29. What happens to the default host firmware policy after a Cisco UCS Manager upgrade?

30. An engineer is asked to use SaaS to manage Cisco computing.

Which two items are needed to accomplish the task? (Choose two.)

31. An engineer is configuring a backup operation on the existing Cisco UCS environment using a logical configuration.

Which configuration is expected to be saved by using this backup type?

32. An engineer is seeking the most optimal on demand CPU performance while configuring the BIOS settings of a UCS C-series rack mount server.

What setting will accomplish this goal?

33. An engineer is duplicating an existing Cisco UCS setup at a new site.

What are two characteristics of a logical configuration backup of a Cisco UCS Manager database? (Choose two.)

34. Refer to the exhibit.

Which two Cisco UCS components are upgraded as a result of the configuration? (Choose two.)

35. Which two settings must be configured before enabling a Cisco UCS Manager domain for Cisco Intersight connectivity? (Choose two.)


 

New Cisco Certified DevNet Professional 300-910 DEVOPS Exam Dumps
Cisco Certified DevNet Professional Certification 300-915 DEVIOT Dumps Questions

Add a Comment

Your email address will not be published. Required fields are marked *