New 200-301 Exam Dumps Online 100% Passing Guarantee

New 200-301 exam dumps online are good for your Cisco Certified Network Associate certification exam with 100% passing guarantee. CCNA 200-301 exam dumps V11.02 contain 102 practice exam questions and answers. It is highly recommended to read CCNA 200-301 dumps questions and answers carefully, and try to understand all the 200-301 exam Q&As. We ensure that you can pass 200-301 Cisco Certified Network Associate certification exam.

Read 200-301 CCNA Free Dumps V11.02 Online

1. Refer to the exhibit.

Which type of route does R1 use to reach host 10.10.13.10/32?

2. Refer to the exhibit.

Which prefix does Router1 use to Host A?

3. DRAG DROP

Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.

4. A frame that enters a switch fails the Frame Check Sequence.

Which two interface counters are incremented? (Choose two.)

5. DRAG DROP

Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right.

6. How do TCP and UDP differ in the way that they establish a connection between two endpoints?

7. Which 802.11 frame type is association response?

8. In which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?

9. Which statement identifies the functionality of virtual machines?

10. Which command automatically generates an IPv6 address from a specified IPv6 prefix and MAC address of an interface?

11. When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two.)

12. DRAG DROP

Refer to the exhibit.

Drag and drop the networking parameters from the left onto the correct values on the right.

13. What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?

14. An engineer must configure a /30 subnet between two routes.

Which usable IP address and subnet mask combination meets this criteria?

15. Which network allows devices to communicate without the need to access the Internet?

16. Refer to the exhibit.

Which statement explains the configuration error message that is received?

17. Which IPv6 address type communication between subnets and cannot route on the Internet?

18. Which IPv6 address block sends packets to a group address rather than a single address?

19. What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two.)

20. What is a benefit of using a Cisco Wireless LAN Controller?

21. Which action is taken by switch port enabled for PoE power classification override?

22. Which statement about Link Aggregation when implementing on a Cisco Wireless LAN Controller is true?

23. Which two conditions must be met before SSH can operate normally on a Cisco IOS switch? (Choose two.)

24. Refer to the exhibit.

Which password must an engineer use to enter the enable mode?

25. Refer to the exhibit.

Which action do the switches take on the trunk link?

26. What is the primary effect of the spanning-tree portfast command?

27. Which result occurs when PortFast is enabled on an interface that is connected to another switch?

28. Which QoS Profile is selected in the GUI when configuring a voice over WLAN deployment?

29. Refer to the exhibit.

After the switch configuration, the ping test fails between PC A and PC B.

Based on the output for switch 1, which error must be corrected?

30. DRAG DROP

Drag and drop the WLAN components from the left onto the correct description on the right.


 

Real CCNP Security 300-730 SVPN Exam Dumps Is Available
How to prepare for Cisco 300-835 CLAUTO exam well?

Add a Comment

Your email address will not be published. Required fields are marked *